ENGLISH

Easy Setup Procedure

rStarting Auto Setup

1Press F to start the Auto Setup.

• Start the measurements.

Measurement of each channel is performed as follows:

1

2

FL FR C SW SL SR SBLSBR

1: The subwoofer speaker is measured twice.

2: Not displayed when “ZONE2” is set at “Setting the Power

Amplifier Assignment” ( page 43).

After each channel is measured, “Calculating” appears. The display switches to the speaker check display automatically.

M e a s u r e : F L < C c l

C a l c u l a t i n g

S p e a k e r : 3 / 4 / . 1

¢Check the results of the speaker detection

Example: 7.1-channel systems

S p e a k e r : 3 / 4 / . 1

Subwoofer

Surround and Surround back speaker

Front and Center speaker

2 Press D H to select “Store”, then press F.

Store:

Store the checked measurement values.

All parameters are stored.

Retry:

Measure again.

Cancel:

Cancel the checked measurement values.

3 Disconnect the setup mic to finish Auto Setup.

1

A u t o S e t < S t a r t

2

S e t u p < S t o r e

S t o r i n g

•When measurements have been made using the measurement microphone, speakers with a built-in filter such as subwoofers might be set with a value that differs from the physical distance because of the internal electrical delay.

NOTE:

•Do not change the speaker connections or subwoofer volume after making the measurements.

•Do not turn off the power while the data is being stored.

Easy Setup Procedure

Cautions during measurements:

•Loud test tones are output during the measurements. Be careful for example when small children are nearby.

•Proper measurements may not be possible if there are obstacles between the speaker and the setup microphone.

•During the measurements, do not stand between or near the speakers and setup microphone.

•To avoid influencing the measurements, turn off the power of air- conditioners or any other equipment producing sound in the room. Perform the measurements with the room as quiet as possible.

•Measurement is cancelled when VOLUME is operated while the Auto Setup is performed.

¢About automatic retry

To confirm the results of the measurements, remeasurement is automatically performed.

Remeasurement is performed up to two times. During this time, “Retry1” or “Retry2” is displayed on the display.

O v e r l o a d R e t r y 1

11

ENGLISH