Epson C63, C64, C83, C84, C64, C83 manual 26

EPSON Stylus C63/64/83/84 Revision A

ADJUSTMENT ￿ When you replace Holder pulley driven with new one,

REQUIRED lubricate it with the suitable amount of G-65 grease by the specified position.

￿When you replace Front frame with new one, lubricate it with the suitable amount of G-58 grease by the specified position.

￿When you replace IC holder or Print head assy. with new one, lubricate it with the suitable amount of G-58 grease by the specified position.

￿When you replace Pulley driven shaft with new one, lubricate it with the suitable amount of G-58 grease by the specific position.

￿When you replace Pulley driven holder with new one, lubricate it with the suitable amount of G-58 grease by the specific position.

￿When IC holder/PW sensor/CR encoder sensor is removed or replaced with new one, the following adjustment must be performed in the order below.

1)Top margin adjustment

2)PF adjustment

3)Bi-d adjustment

4)Head angular adjustment

5)1st dot adjustment

6)PW sensor adjustment (Only for SC83/84)

7)CR motor drive torque dispersion measurement

￿When Print head assy. is removed or replaced with new one, the following adjustment must be performed in the order below.

1)Head ID input

2)Top margin adjustment

3)PF adjustment

4)Bi-d adjustment

5)Head angular adjustment

6)1st dot adjustment

7)PW sensor adjustment (Only for SC83/84)

8)CR motor drive torque dispersion measurement

ADJUSTMENT ￿ When CR timing belt is removed or replaced with new one,

REQUIRED tension adjustment of CR timing belt must be performed by the degital tension gauge.

Disassembly and Assembly Disassembly 26