EPSON Stylus C63/64/83/84

Revision A

1.3.11 Paper guide front removal

￿External view

Porous Pad, Paper guide front

Screw type : CBS TITE SCREW, 3x6, F/Zn

Order of tightening : First Thghtening torque : 8±1 kgf.cm

Ribs of Paper guide front

Paper guide front

￿Removal procedure

1)Remove one screw for securing Paper guide front to main frame, and remove Paper guide front with pulling the left side of Paper guide front slightly.

￿Do not touch the rib of Paper guide front and [Porous Pad,

CAUTION

Paper guide, Front].

 

￿ Do not touch eight feet of [Porous Pad, Paper guide, Front;Sub].
￿ When assembling Paper guide front to main frame,

￿

Do not touch the rib of Paper guide front and [Porous

 

Pad, Paper guide, Front].

￿

Make sure to install the dowels of Paper guide front into

 

the holes of main frame.

45-degrees

Angle of two feet is within 45-degrees. (If angle is over 45-degrees, these feet is set on the position without [Porous Pad, Ink Eject].)

HP side

 

Far side

 

 

 

Remaining feet should be vertically set be touched to [Porous Pad, Ink Eject]

￿ Make sure that there is no gap between Paper guide
front and main frame.
￿ Be careful not to bend eight feet of [Porous Pad, Paper
guide, Front; Sub] in assembling/disassembling.
￿ Wipe off drain ink on ribs of Paper guide front by the
cotton stick. (In this time, do not touch the cotton stick
to [Porous Pad, Paper Guide Front] that soluble oid is
included.)
Figure 1-17. Paper guide front removal

￿Part/Unit that should be removed before removing Paper guide front Housing (Right/Left/Frame) / CR unit with Front frame / Paper eject roller

ADJUSTMENT ￿ When Paper guide front is removed or replaced with newREQUIRED one, the following adjustment must be performed in the order below.

1)Top margin adjustment

2)PF adjustment

3)Bi-d adjustment

4)Head angular adjustment

5)1st dot adjustment

6)PW sensor adjustment (Only for SC83/84)

Disassembly and Assembly

Disassembly

28