FEDERAL COMMUNICATIONS COMMISSION (FCC) RADIO FREQUENCY INTERFERENCE
STATEMENT
Class B Computing Device
Note: This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in
aresidential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will occur in a particular installation. If this equipment does not cause harmful interference to radio or television reception, which can be determined by tur+
ning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
FCC WARNING: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
CANADIAN DEPARTMENT OF COMMUNICATIONS (DOC) NOTICE
“This digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus as set out in the
The information in this User’s Manual has been carefully reviewed and is believed to be accurate. The vendor assumes no responsibility for any inaccuracies that many be contained in this document, makes no commitment to update or to keep current the information in this manual, or to notify any person or organization of the updates.
Epson reserves the right to make changes to the product described in this manual at any time without notice. This product, including software, if any, and documentation may not, in whole or in part, be copied, photocopied, reproduced, translated or reduced to any medium or machine without prior written consent.
In no event will Epson be liable for direct, indirect, special, incidental, or consequential damages arising from the use or inability to use this product or documentation, even if advised of the possibility of such damages. In particular, the vendor shall not have liability for any hardware, software, or data stored or used with the product, including the costs of the repairing, replacing, or recovering such hardware, software, or data.
Manual Copyright, 1995 Epson. All rights reserved.
ATA/IDE Owner’s Manual | 2 |