Sub Menu Function
Power Consumption You can set the Lamp brightness to one of two settings.
Select ECO if the images being projected are too bright such as when projecting images in a dark room or onto a small screen. When ECO is selected,
power consumption during projection and the lamp life change as follows, and fan rotation noise is reduced. Electrical consumption: about 25%
decrease, lamp life: about 1.4 times longer
Volume You can adjust the Volume. Setting details are saved for each image signal.
Mic Input Level Adjust this if the microphone input level is low and the microphone audio output from the projector's speaker is difficult to hear, or if the input level is
too high, resulting in a crackling sound in the audio from the microphone. When Mic Input Level is turned down to 0, no microphone audio is output
from the speaker.
Remote Receiver You can limit the reception of the operation signal from the Remote Control.
When you want to prohibit operation by Remote Control, or if the Remote Receiver has a fluorescent light too close to it, you can make settings to
deactivate the remote receiver you do not want to use or that is experiencing interference.
User Button You can select the item from the Configuration Menu with the Remote Control's User Button. By pressing the User Button the assigned menu item
selection/adjustment screen is displayed, allowing you to make one-touch settings/adjustments. You can assign one of the following items to the User
Button.
Power Consumption, Info, Progressive,Test Pattern, Resolution, Mic Input Level, and Pattern Display
Pattern Pattern Display: Display a pattern.
Pattern Type: You can select from Patterns 1 to 4 or User Pattern. Patterns 1 to 4 display projection lines such as ruled lines or a grid.
Pattern 1: Pattern 2: Pattern 3: Pattern 4:
User Pattern: Captures a user pattern. s p.70
Test Pattern: When the projector is set up, a test pattern is displayed so that you can adjust the projection status without connecting equipment. While
the Test Pattern is displayed, zoom, focus adjustments, and Keystone correction can be performed. To cancel the Test Pattern, press the [Esc] button on
the Remote Control or the Control panel.
Attention
If a pattern is displayed for a long time, a residual image may be visible in projected images.
Reset You can reset all adjustment values in the Settings Menu to their default settings, except for User Button.
To return all menu items to their default settings, see s p.91
List of Functions
77