38

Changing Settings Using a Web Browser (Web Control)

You can set up and control the projector from a computer by using the
Web browser of a computer that is connected to the projector via a
network. Setup and control operations can be performed remotely if
this function is used. In addition, since you can use the computers
keyboard, entering characters required for the setup is easier.
Use Microsoft Internet Explorer 6.0 or later as the Web browser. If
using a Macintosh, you can also use Safari. If, however, you are using
Safari under Macintosh 10.2.8, some of the Web control radio buttons
may not display properly.
Displaying Web Control
Display Web control with the following procedure.
fEntering the IP address of the projector
Web control can be opened by specifying the IP address of the projector
as follows when using "Advanced Connection Mode".
AStart the Web browser on the computer.
BEnter the IP address of the projector in the address
bar of the Web browser, and press the [Enter] key on
the computer’s keyboard.
Web Control is displayed.
Projector Setup
You can set items that are usually set in the projector’s configuration
menu. The contents set are reflected in the configuration menu.
fItems in the configuration menu that cannot be set by the
web browser
All items in the configuration menu can be set with the exception of the
following items.
• "Settings" - "Pointer Shape", "EasyMP Audio Out"
• Registering a user’s logo using "Extended" - "User’s Logo"
• "Extended" - "Operation" - "High Altitude Mode"
• "Extended" - "Link21L", "Language"
• "Reset" - "Reset All", "Reset Lamp Hours"
The items available on each menu are the same as the configuration menu
of the projector.
sUser’s Guide "List of Functions"
sUser’s Guide "Network Menu (EMP-1715/1705 Only)"
The "MAC Address" is not displayed.
qSetup and control with a Web browser are possible if set to
"Network ON" in the "Extended" menu of the projector’s configuration menu, even if the projector is in standby mode (when the power is off).
qIf your Web browser is set up to connect via a proxy server,
Web control cannot be displayed. To use the Web control, you need to make network connection settings with other than a proxy server.
Procedure