Epson EMP-1705/1700, EMP-1715/1710 f t Power indicator lights red

Problem Solving 43

f t Power indicator lights red					Abnormal
							: Lit	: Flashing:	: Off
		Status		Cause		Remedy or Status
	Red Red		Red	Internal Error	Stop using the projector, disconnect the power cable from the electrical outlet, and contact your local dealer or the nearest
					address provided in the World-Wide Warranty Terms. s Inquiries
	Red		Red	Fan Error	Stop using the projector, disconnect the power cable from the electrical outlet, and contact your local dealer or the nearest
				Sensor Error	address provided in the World-Wide Warranty Terms. s Inquiries
	Red		Red	High Temp Error	The lamp turns off automatically and projection stops. Wait for about five minutes. After about five minutes the projector
				(overheating)	switches to standby mode, so check the following two points.
					• Check that the air filter and air exhaust vent are clear, and that the projector is not positioned against a wall.
					• If the air filter is clogged, clean or replace it. s p.54, 59
					If the error continues after checking the points above, stop using the projector, disconnect the power cable from the
					electrical outlet, and contact your local dealer or the nearest address provided in the World-Wide Warranty Terms.

sInquiries

When using at an altitude of 1500 m or more, set "High Altitude Mode" to "On". s p.36

Red Red	Lamp Error	Check the following two points.
	Lamp Failure	• Take out the lamp and check if it is cracked. s p.56
	Lamp Cover Open	• Clean the air filter. s p.54

If it is not cracked _ Re-fit the lamp and turn on the power.

If the error continues _ Replace the lamp with a new lamp and turn on the power.

If the error continues _ Stop using the projector, disconnect the power cable from the electrical outlet, and contact your local dealer or the nearest address provided in the World-Wide Warranty Terms.

sInquiries

If it is cracked _ Replace it with a new lamp, or contact your local dealer for further advice. If replacing the lamp yourself, be careful to avoid pieces of broken glass (you cannot continue projecting until the lamp is replaced).

Check that the lamp cover and the lamp are securely installed. s p.56

If the lamp cover or the lamp is not securely installed, the lamp does not switch on.

When using at an altitude of 1500 m or more, set "High Altitude Mode" to "On". s p.36