Epson EMP-61, EMP-81/61 Useful Functions, Troubleshooting, Using the help function, Checking the indicators, • sRGB, Normal, 1 Press, • Dynamic, • Theatre, • Living Room

Useful Functions

Colour mode The following six preset types of colour mode can be selected by

selection pressing on the remote control.

• Dynamic	• Presentation	• Theatre
• Living Room	• sRGB	• Blackboard

A/V Mute Playback of images and sound can be momentarily paused and

then resumed each time on the remote control is pressed.

User's Guide

"Selecting the Projection

Quality (Colour Mode

Selection)"

User's Guide

"A/V Mute"

Troubleshooting

Using the help function

1 Press .

2 Select the item to view.

Tilt on the remote control or press andon the projector's control panel to select an item.

	User's Guide
	"Troubleshooting"
3	Accept the selection.
	Press the to confirm the selection of a menu
	item.
4	The help contents will then be displayed.

The help menu is cleared when is pressed.

Checking the indicators

These indicators alert you to problems with projector operation. The following tables show what the indicators mean and how to remedy problems that they indicate.

Refer to "Problems Solving" in the User's Guide for further details.

If all indicators are switched off, check that the power cable is connected correctly and that power is being supplied normally.

Problem/Warning	Lit	Flashing	Off
Status	Problem and remedy
Power Red High temperature inside projector (overheating)

Red

The lamp will turn off automatically and projection

will stop. Wait for about 5 minutes. Then press to turn the projector back on.

Normal			Lit	Flashing	Off
Status		Problem and remedy
Power	Orange Standby condition
		The power cable should only
		be disconnected in this
		condition.
		Projection starts when you
		press	.
Power	Green	Warm-up in progress
		After warm-up finishes,
		projection starts when an
		image signal is input.
Power	Green	Projection in progress
Power	Orange Cool-down in progress
		The projector changes to
		standby (indicator lights
		orange) after about 20
		seconds.

Printed in China 04.XX-.XA(G04) 405128100E

Power Red Lamp problem

Red

Remove the lamp and check if it is broken. If the lamp is not broken, reinsert it. If the lamp is broken replace it with a new lamp, or contact your local dealer for further advice. *1

Power	Red	Internal problem
Red		Stop using the projector and send it for service. *2
Red
Power	Red	Something is wrong with the fan or the sensor.
Red		Stop using the projector and send it for service. *2
Power	Red	High-speed cooling in progress. If the temperature
Orange		rises too high again, projection will stop automatically.
		Check that the air filter and air exhaust vent are clear,
		and that the internal room temperature is not too high.
Power		It is time to replace the lamp.
Orange		Replace the lamp with a new one as soon as
		possible.
		If you continue to use the old lamp, the possibility that
		the lamp may break will increase.

*1 Contact your dealer for a spare lamp.

*2 For repairs, contact your dealer or the nearest address provided in the "International Warranty Conditions" section in the Safety Instructions/World-Wide Warranty Terms booklet.