Epson EMP-61, EMP-81/61 Connecting to a Video Source, Preparation before Projecting, Press, power, source, [Audio] port, [Audio] port, the projector, electrical outlet

Connecting to a Video Source

User's Guide

"Connecting to a Video Source"

Turn off the power for both the projector and the video source before connecting them.

			[Video] port (yellow)		[Audio] port
	To video	When connecting to a video
		source with a video output port
	output port
		yellow	yellow
white				white	[Audio] port
			A/V cable	To [Audio] port	[S-Video] port
To audio	red	(commercially-available)		Connect the cable
			red	using the audio
output port
				adapter that is supplied
To S-Video				with the projector.	When connecting to a
output port			S-Video cable (commercially-available)		video source with an
					S-Video output port

*To play sound through the projector's built-in speaker, use the audio adapter (supplied with the projector) to connect an A/V cable (commercially available) to the [Audio] input port corresponding to the connected video source.

If connecting a component video source (such as a DVD player), you can use the optional component video cable to connect the source to the Computer/Component Video port at the

Tip rear of the projector.

Preparation before Projecting

1	Remove the lens cover.
2	Insert the projector's power cable into
	the projector.
3	Insert the power cable into an earthed
	electrical outlet.
	The Power indicator will light orange.
4	Turn on the power for the signal input
	source.
	For video equipment, press [Play] to start
	playback.
5	Press	to turn on the projector's

power.

A beep will sound to indicate that the projector is starting up.

The Power indicator will flash green, and projection will then start (warm-up in progress). The Password Protect setting may cause the password entry screen to be displayed each time the power is turned on.

If this happens, enter the password.

User's Guide "Preventing theft (Password Protect)"

When the "Extended" - "Operation" - "Direct Power ON" menu item is set to "ON", a confirmation buzzer sounds and the projector's power turns on as soon as the power plug is inserted into the electrical outlet, and projection then starts.

User's Guide "Extended" Menu

1

5

Tip

User's Guide

"Turning On the Projector"

Power indicator

3

2

If no images are projected, change the input signal.

Remote control

Projector

If connecting to a computer with a built-in monitor, or to a laptop computer, you may need to change the output destination using the buttons or setting menus on the computer or laptop computer.

User's Guide "Turning On the Power and Projecting Images"