Connecting to a Computer
■ ■ ■ ■ ■
■
11
2. To use the remote control as a wireless mouse, connect
the 9-pin end of the PS/2 mouse cable or USB mouse
cable included with the projector to the MOUSE terminal
on the square end of the main cable.
3. Disconnect your mouse from the mouse port on the back
of your computer and replace it with the other end of the
PS/2 mouse cable or USB mouse cable included with the
projector. (Your computer’s mouse will be disabled while
you are using the remote control as a mouse.)
♦
Note:
If your system uses a serial mouse, perform steps 2 and 3
using the PC mouse serial cable instead of the PS/2 mouse cable
or USB mouse cable (not shown in the illustration).
4. To use the ELP Link IV software or to use the Effects
buttons on the remote control, connect one end of the
serial cable to the SERIAL terminal on the square end of
the main cable.
Connect the other end of the serial cable to the serial port on
the back of your computer.
♦
Note:
You will not be able to use ELP Link IV software if your
system has only one serial port that is being used to support a
serial mouse.
5. Tighten the screws on all connectors.