note
When the projector has not received any input signals for 30 minutes, it automatically turns off the projector lamp and enters “sleep mode.” This conserves electricity, cools the projector, and extends the life of the lamp. If you are done using the projector, unplug the power cord. If you want to start projecting again, press the P Power button. You can turn sleep mode on or off through the Extended menu. See page 59.
caution
To avoid damaging the projector or lamp, never unplug the power cord when the Power light is green or flashing orange.
3.Press the P Power button again. The lamp turns off, and the Power light flashes orange for about 20 seconds as the projector cools down. When the projector has cooled, it beeps twice to indicate that power is off. The Power light stays orange and the exhaust fan shuts off.
If you want to turn the projector on again, wait until the orange light stops flashing. Then press the P Power button.
4.Press up on the blue foot release lever and lower the projector to retract the front adjustable foot, as shown.
5.Replace the lens cap and unplug the power cord.
6.Turn off and disconnect any equipment plugged into the projector.
42Projecting