Setting a Password

1.Press the Freeze button on the remote control for about 5 seconds until you see the Password Protect menu:

2.Select Password and press Enter. You see the message Change the password?

3.Select Yes and press Enter.

4.Hold down the Num key on the remote control and use the numeric keypad to enter a 4-digit password.

The password will be displayed as ****. After you enter the last digit, a confirmation screen appears. Enter the password again.

5.After you finish setting the password, press the Esc button to return to the Password Protect menu.

Make a note of the password and keep it in a safe place in case you forget it.

Turning On the Password and User’s Logo

1.To enable the password, press the Freeze button on the remote control for about 5 seconds until you see the Password Protect menu

2.Select Power ON Protect and press Enter.

3.Select ON and press Enter. Then press Esc.

note

If a password has already been set, you see the Password Protect Release screen. See “Starting the Projector with a Password” on page 66.

Hold down this button to activate the numeric keypad

Use these buttons like a numeric keypad to enter the password

Fine-tuning the Projector 65