■The attached computer may be in sleep mode or displaying a black screen saver. Try pressing a key on the computer.

■If you’re projecting from a video source, press the Play button on your video equipment.

Nothing appears on the external monitor.

■Make sure the VGA computer cable is connected to your computer’s video port and the projector’s

Computer1/Component Video1 port. It will not work if you connected the computer cable to the projector’s

Computer2/Component Video2 port.

■Make sure the cable from your monitor is connected to the projector’s Monitor Out port.

You see a blue screen with the message No Signal displayed.

■Make sure the cables are connected correctly, as described in Chapter 1.

■Make sure the power to your computer or video source is turned on.

■If you’ve connected a computer and one or more video sources, you may need to press the Source Search button on the projector, or the Comp 1, Comp 2, S-video, or Video button on the remote control to select the correct source. Allow a few seconds for the projector to sync up after pressing the button.

■If you’ve connected a notebook computer, make sure it’s set to display on an external monitor. See page 33.

82Solving Problems