Installing the Network Image Express Card

Install the Network Image Express Card in your scanner by following the steps below.

1.Turn off the scanner. Unplug any power cords, and then disconnect all cables from the back panel of your scanner.

2.Remove the two screws using a cross-head screwdriver, and then remove the plate. Be sure to keep both screws; you may need to use them again if you re-install the shield plate.

3.Insert the Network Image Express Card in your scanner’s optional interface slot and then tighten the screws.

cCaution:

Do not install or uninstall the Network Image Express Card from the scanner while the scanner is turned on; otherwise damage may occur.

4.Initialize the Network Image Express Card. To initialize, turn on the scanner while holding down the Reset button of the Network Image Express Card for 10 seconds until the red status light and green data light turn on.

Note:

Be sure to initialize the Network Image Express Card when you insert or re-insert it in the scanner.

5.Turn off the scanner.

Options 27