LF button -- stands for line feed. When you’re off line, tapping this button advances the paper one line at a time. To advance multiple lines, hold down the LF button. Do not perform continuous line feeds for more than two minutes.

SHEET LOAD button -- opens the paper bail and loads single- sheet paper into the printer.

The paper-out detector

The printer is equipped with a device which warns you that the printer is out of paper. When your paper runs out, printing stops, the PAPER OUT light goes on, and the printer buzzer sounds five times.

When you have loaded more paper, the PAPER OUT light goes off. Printing can be resumed in one of two ways. If you are in the middle of printing, press the ON LINE button. If you want to reinitialize the printer, turn the power switch OFF and then back ON.

You can turn off the paper-out detector in two ways: by DIP switch 1-2 on the interface card, or by a control code sent from the computer. Turning off the paper-out detector tells the printer to ignore the paper- out sensor and allows you to print to the bottom of the page. Some computers will stop the printer before the end of the page, even though DIP switch 1-2 is down (off). If this happens, you may need to consult your dealer about the interface between your computer and printer. You may also consult your software dealer for further infor- mation.

Maintenance

As with any mechanical device, the best maintenance of your LQ-1500 is preventive maintenance. You’ve already started by choosing a clean, dust-free location with a comfortable temperature range. Of course, you will change your ribbon cartridge whenever it loses quality through use.

In addition, your printer requires periodic cleaning. Here are a few tips on how to perform this maintenance properly.

Cleaning the LQ-1500

You should clean the outside of the printer case whenever it appears to be dirty. Use a clean damp rag and alcohol. Be careful not to drip alcohol on the printer mechanism.

27