Epson LQ-2180 Advancing the Paper to the Tear-OffEdge

EPSON LQ-2180

Advancing the Paper to the Tear-Off Edge Adjusting the tear-off position

If you use the front or rear push tractor, you can use the tear- off feature to advance your continuous paper to the printer’s tear-off edge when you finish printing. You can then easily tear off the printed document. When you resume printing, the printer automatically feeds the paper back to the top-of-form position so that you can save the paper normally lost between documents.

As described below, you can use the tear-off feature in two ways: manually by pressing the printer’s Tear Off/Bin button, or automatically by turning on the auto tear-off mode.

If the perforation between pages is not aligned with the tear- off edge, you can adjust the position of the perforation using the micro adjust feature. For instructions, see “Adjusting the tear-off position” on this page.

Caution:

Never use the tear-off feature (by pressing the Tear Off/ Bin button or turning on the auto tear-off mode as described below) to feed continuous paper with labels backward; they may come off their backing sheet and jam the printer.

Using the Tear Off/Bin button

After the printer finishes printing your document, check that the Tear Off/Bin lights are not flashing. Then press the Tear Off/Bin button. The printer advances the paper to the tear-off edge.

Note:

If the Tear Off/Bin lights are flashing, the paper is in the tear-off position. If you press the Tear Off/Bin button, the printer feeds your paper to the next top-of-form position.

If your paper’s perforation is not aligned with the tear-off edge, you can use the micro adjust feature to move the perforation to the tear-off position. Follow the steps below.

Caution:

Never use the knob to adjust the tear-off position while the printer is turned on; this may damage the printer or cause it to lose the tear-off position. The knob can be used when the printer is turned off only.

Note: Your tear-off position setting remains in effect until you change it, even if you turn off the printer.

1.Make sure the Tear Off/Bin lights are flashing (the paper is at the current tear-off position). You may need to press the Tear Off/Bin button to advance the paper to the tear-off position.

2.Open the paper guide cover.

3.Hold down the Pause button for about three seconds. The Pause light begins flashing and the printer enters the micro adjust mode.

4.Press the LF/FF D button to feed the paper backward, or press the Load/Eject U button to feed the paper forward until the paper perforation is aligned with the tear-off edge.

tear-off-edge

Advancing paper to the tear-off position automatically

To automatically advance your printed documents to the tear- off position, you need to turn on the auto tear-off mode and select the appropriate page length for continuous paper in the default-setting mode. For instructions, see “About Your Printer’s Default Settings” on page 26.

When auto tear-off is on, the printer automatically advances the paper to the tear-off position whenever it receives a full page of data or a form feed command followed by no more data.

Note:

The printer has a minimum and a maximum tear-off position. If you try to adjust the tear-off position beyond these limits, the printer beeps and stops moving the paper.

5.After you set the tear-off position, press the Pause button to turn off the micro adjust mode.

6.Tear off the printed pages.

When you resume printing, the printer automatically feeds the paper back to the top-of-form position and begins printing.

2/99 EPSON LQ-2180 - 23