Epson LQ-2180 manual 25

EPSON LQ-2180

6.After you remove the new ribbon cartridge from the package, remove the separator from the middle of the ribbon cartridge and discard the separator. Then turn the ribbon-tightening knob in the direction of the arrow to remove any slack in the ribbon.

separator

ribbon-tightening knob

7.Hold the cartridge with the ribbon-tightening knob up. Fit the two front notches (c) of the ribbon cartridge over the

small pegs on each side of the printer as shown below. Then lay the cartridge flat so that the rear notches (d) fit over the corresponding pegs.

8.Gently press down the cartridge until both ends click into place.

9.Lift the ribbon guide of the ribbon cartridge (c) and insert it firmly over the metal pins behind the print head (d). Make sure the ribbon is not twisted or creased and that it is in place behind the print head. Press down the guide until it clicks into place.

ribbon guide

ribbon-tightening knob

10.Turn the ribbon-tightening knob in the direction of the arrow to remove any slack in the ribbon as shown in step 9. Then slide the print head from side to side to make sure it moves smoothly.

11.Replace the printer cover by first inserting the front tabs into the slots on the printer (c) and then lowering the cover until it clicks into place (d).

2/99 EPSON LQ-2180 - 25