Open the pin feed covers as shown on the previous page and feed the paper under the paper separator and into the paper slot. Push the paper through until it comes up between the ribbon guide and the platen. Pull the paper up until the top is above the pin-feed holders; fit the holes on the left side of the paper over the pins in the left holder; then close the cover.

Fit the right side of the paper in the right holder, moving the holder as needed to match the width of the paper. Close the second cover, making sure the paper has no dips or wrinkles; then lock the right holder in place with the locking lever. Push the paper bail against the paper.

Now you are ready to set the top of page position.

Turn the paper feed knob to advance the paper until a perforation between sheets is approximately l/8 of an inch below the top of the ribbon guide, as shown in the illustration.

When you turn on your LX-90, it remembers this top of page setting and uses it when any program (or the FF button) tells it to move to the top of the next page.

9