(2) Removal of protective paper for paper end detector

The MX-80 F/T is provided with a protective paper inserted between the inner and outer paper guides to protect the paper end detector from damage due to shocks or vibrations during transportation. Before using the Printer, be sure to remove this paper. If the MX-80 F/T is to be reshipped. remember to return it to the original position.

(3) Removal of shipping screws

The purpose of the shipping screws is to protect the MX-80 F/T against any damage that may be caused by shocks or vibrations during transportation. Therefore, before operating the MX-80 F/T, remove the screws as described below. (See Fig. 3.)

STEP 1. Open the printer lid.

STEP 2. Remove with a screwdriver, the two shipping screws visible inside the printer mechanism.

Shipping Screws

Fig. 3 Removal of Shipping Screws

NOTE: Save the two shipping screws for possible future use.

<SUPPLEMENT>

0 If the printer lid is an obstacle when removing the shipping screws, be sure to take off the printer lid by observing the following steps. Rough or careless handling of the printer lid may result in damage to. or even breakage of its hinges.

Step 1. Stand the printer lid upright.

Step 2. Push the printer lid toward the right and pull up its left side. (See Figs. 4 (1) and (2).)

- 4 -