3.Put base plate C on stand A and secure it by inserting two screw grommets E to the corresponding square holes as shown in Fig. 3. In this case, take note of the direction in which base plate C must be placed on the stand.

I

Fig. 3 Mounting of Base Plate on Stand

4.Set tension lever F on stand A as follows:

4-1: Hook the tension lever on the nose of stand A as shown in Fig. 4-1.

4-2: While pulling the tension lever up, put the wire into the hole as shown in Fig. 4-2.

Fig. 4-1

5. Fig. 5 shows the Roll Paper Holder in the assembled state.

Fig. 5 Assembled Roll Paper Holder

- 5 0 -