6.12Set Absolute Horizontal Print Position “ESC ( $ nL nH m1 m2 m3 m4”
Format: |
|
|
|
|
|
|
|
|
|
ASCII | ESC | ( | $ | nL | nH | m1 | m2 | m3 | m4 |
HEX | 1B | 28 | 24 | nL | nH | m1 | m2 | m3 | m4 |
Decimal | 27 | 40 | 36 | nL | nH | m1 | m2 | m3 | m4 |
Range of Definition:
nL=04H, nH=00H
0≤ (m4x256x256x256 +m3x256x256 + m2x256 + m1))x(Absolute horizontal position setting units) inch ≤ 1FFFFFFFH/1440 inch
Function:
-The printing position in the X direction is set to a position spaced in the positive direction from the origin on the X axis (left margin position) in the position management coordinate system by (m4 x 256 x 256 x 256 + m3 x 256 x 256 + m2 x 256 + m1) x (absolute horizontal position setting unit) inches. The default value of absolute horizontal position set unit is 1/60 inch unit.
-If the left margin position + ( m4 x 256 x 256 x256 + m3 x 256 x 256 + m2 x 256 + m1) x (absolute horizontal position set unit) is higher than the right margin position, this command is ignored.
-This Command is effective only at the time of the graphic mode.
[Initial State] | - |
Related Commands:
Commands related in the direction of applying an effect (Setting) None
Commands related in the direction of receiving an effect (Setting) None
Commands related in the direction of applying an effect (Operation) None
Commands related in the direction of receiving an effect (Operation)
ESC I command changes the cardinal point of absolute position set.
If ESC Q command is higher than the right margin position, this command is ignored.
The absolute horizontal position setting units are set by the ESC (U command. The absolute horizontal position setting units are reset to their initial states by the ESC @ and ESC (G commands.
6.13Set Relative Horizontal Print Position “ESC (/ nL nH m1 m2 m3 m4”
EPSON Imaging Technology Center | Page: 36 |
Revision: 1 (Date: 6/20/00) |
|