Epson PM-7000C manual 42

6.17Select Mechanism Sequence “SN”

The printer driver can control the head gap by this SN command.

Format:
ASCII	S	N	03H	00H	00H	m1	m2
Hex	53	4E	03	00	00	m1	m2
Dec	83	78	03	00	00	m1	m2

Parameters:

The following m1 and m2 parameters are each one byte binary values that indicates mechanism sequences.

m1	m2	Description	Comment
00H	--	Feed paper sequence setting	Not used for Stylus Pro 7000
01H	00H	Default PG Setting	Platen gap setting
	01H		PG High
00H	02H-FHH		Reserved
02H-FFH		Reserved

Function:

-The default environment mechanism sequence is set

-If parameter m1, m2 are out of range (02H=FFH), this command is ignored and the current setting is maintained.

-While in the EPSON Remote Mode, ESC/P2 commands are not recognized by the printer until “ESC 00H 00H 00H” is invoked to exit this Mode.

-Remote Mode commands should be sent prior to sending ESC/P2 commands.

-This command is only valid in Remote Mode.

EPSON Imaging Technology Center	Page: 42
Revision: 1 (Date: 6/20/00)