6.22Set Pause After Printing “PZ” 02H 00H 00H m1

Format:

“PZ” 02H 00H 00H m1

Parameters:

Parameter m1 is one byte binary code, and indicates the state as follows:

Set Pause After

m1

Printing

 

Off

00H

On

01H

Reserved

02H - FFH

Function:

-The default pause state after printing is set.

-If the pause after printing is ON, the printer is stopped at the pause state after the FF command is executed.

-If the auto cutting is set, it is pausing after cutting / printing horizontal lines.

-If parameter m1 is out of range, this command is ignored and the existing setting is maintained.

-This command is only valid in remote mode.

Exception:

-If the banner mode is set, it processes after the LD command is executed and not after the FF command.

EPSON Imaging Technology Center

Page: 47

Revision: 1 (Date: 6/20/00)