6.20Set Drying Time “DR” 04H 00H 00H m1 m2 m3

Format:

“DR” 04H 00H 00H m1 m2 m3

Parameters:

The m1, m2 and m3 are each one byte binary parameters. Parameter m1 indicates the state as follows:

Drying Position

m1

Per scan

00H

Per page

01H

Reserved

02H - FFH

The drying time by the following expression is set by the parameters m2 and m3. If m1=00H(drying per scan), the unit of time is m second. If m1=01H(drying per page), the unit of time is seconds.

(Drying Time) = ((m3 x256) + m2)

m1=00H: 0 ≤ (Drying Time) ≤ 10000 m seconds

m1=01H: 0 ≤ (Drying Time) ≤ 3600 seconds

Function:

-The default environment drying time is set.

-Stop on the position unit set by m1 for the time set by m2 and m3.

-If it is per page, it is waiting for setting time after received FF command. (If the FF command is not received, it doesn’t stop.)

-If parameter m1, m2, and m3 are out of range, this command is ignored and the existing setting is maintained.

-This command is only valid in remote mode.

Exception:

-If the banner mode is set, it processes after the LD command is executed and not after the FF command.

EPSON Imaging Technology Center

Page: 45

Revision: 1 (Date: 6/20/00)