6.19Set Auto Cutting State “ AC” 02H 00H 00H m1

Format: “AC” 02H 00H 00H m1

Parameters:

Parameter m1 is a one byte binary value, and indicates the state as follows:

Set Auto Cutting

m1

Auto Cutting Off

00H

Auto Cutting On

01H

Horizontal print page line On

02H

Blank skip eject mode reset

40H

Blank skip eject mode set

41H

Reserved

03H - FFH

Function:

-The default environment roll paper auto cutting state is set.

-If the auto cutting is on, the roll paper is cut automatically at TOF position just after FF command is executed.

-If the horizontal dot printing is on, it prints horizontal lines at a height of 1 dot at TOF position just after FF command is executed. (for manual cutting)

-If the sheet is set, or if it is not stopped at TOF position just after FF command is executed, it doesn’t cut paper / print horizontal line even if it’s On.

-If parameter m1 is out of range, this command is ignored and the existing setting is maintained.

-This command is only valid in remote mode.

Exception:

-When the banner mode is set, it executes the LD Command, then the FF Command is processed.

EPSON Imaging Technology Center

Page: 44

Revision: 1 (Date: 6/20/00)