4.Focus on the subject and identify the length between the camera lens and the subject.

5.Set the corresponding aperture value from the length and aperture list. For the list of the length and aperture value, see the flash unit manual.

6.Rotate the aperture ring to select the desired value.7.Focus on the subject again and press the shutter-release button down.

Note:

For more information on the flash, see the flash’s manual.

Sequential Number Settings

You can select whether to store photos with sequential numbers.

1.Select Sequential Numbering in the Basic Setup menu using the JOG dial, and press the ENTER button. For details on using the menu, see “Basic Setup menu” on page 40.

The Sequential Numbering screen is displayed.

On (default)

The sequence of numbers continues even

 

when the memory card is replaced.

 

 

Off

The sequence of numbers is reset and a

 

new sequential number is given when

 

replacing the memory card.

 

 

2.Use the JOG dial to highlight On or Off, and press the ENTER button. The new setting is saved and the screen returns to the Basic Setup menu.

Calibrating Indicator Needles

You can check the statuses of the following four factors: the number of remaining photos, photo quality, remaining battery power, and white balance using the needle indicator on the top of the camera. There are 4 needles on the indicator to indicate the statuses of these factors. If any of these needles becomes inaccurate, follow the steps below to adjust it.

1.Select Calibrate Needles in the Camera Settings menu using the JOG dial, and press the ENTER button. The Needle Calibration screen is displayed. For details on using the menu, see “Camera Settings menu” on page 39.

2

2

2

2

2

2

2

2

2

2

Taking Pictures

29