Epson RX600 Loading 35 mm Film Strips in the Film Holder

Epson Stylus Photo RX600

2.Remove the film holder from its storage place. (Remember to replace the film holder when you’re done using it.)

4.Position the film holder so that the 35 mm film strip faces the center of the scanner glass. The positioning posts on the film holder fit in two small holes near the scanner lid, as shown.

Holes

3.Continue with one of these sections:

❏“Loading 35 mm Film Strips in the Film Holder” below (for film)

❏“Placing 35 mm Slides on the Film Holder” on page 14 (for slides)

Loading 35 mm Film Strips in the Film Holder

1. Remove the cover for the film strip holder.

5. Close the scanner lid.

2.Slide your film strip into the holder with the duller (emulsion) side facing up. The top of the images should be facing the outside edge of the film holder and the images should be reversed.

3. Replace the film cover. (It should snap into place.)

Now you are ready copy, print, or scan. See the User’s Guide for instructions.

2/04 Epson Stylus Photo RX600 - 13