Installing the Epson printer interface
1.Check advice note.
Check engineering advice note in case the system is to be installed without prior knowledge of store personnel. Only contact the nominated manager / supervisor in such a situation.
Ensure that the store
2.Identify the EPSON IM-300 terminal.
The EPSON
3.Install the Interface Cable.
WARNING! - RISK OF ELECTRIC SHOCK.
Loosen the screw securing the rear cover of the terminal. Remove the rear cover by pulling the upper part of the rear cover backward then downward.
Identify the COM3 port at the rear of the printer (refer to SHEET
Ensure that the locking hardware is secure.
Replace the rear cover and fasten the securing screw.
4.Check terminal operation.
Before supplying power to the interface connect the power cord back to the terminal and ensure that power is restored. Check the terminal for normal operation (It may be necessary to contact nominated store personnel to do this).
5.Power the interface.
As the interface only passively monitors the data line and the units are
If possible, check that valid text is appearing on Laptop/PC and/or
If the terminal displays abnormal operation, check that all connectors are seated properly. If this does not resolve the problem, return the register to its initial state by removing the interface and contact your FTSS.
SHEET |