EPSON PowerLite TW100 Projector
Switching Between Picture Sources
If the projector is connected to more than one video source, you can use the buttons on the control panel or remote control to switch between the different sources.
Adjusting the Image
There are many ways to adjust the image once it is displayed, as described in the following sections.
On the projector’s control panel, press the Source button to display the currently selected source. Press it again quickly to switch. Continue pressing the button until the name of the source you want is displayed on the screen.
.
Source button
Input buttons
On the remote control, press one of the Input buttons to select the desired source:
| To select the source connected to |
Press this button | this port |
|
|
|
|
Video | Composite video |
|
|
A | Input A component video |
|
|
B | Input B component video or computer |
|
|
|
|
|
|
Adjusting the Height of the Image
The projector should be as perpendicular to the screen as possible. If the image is too low, you can raise it by extending the projector’s front foot.
1.Stand behind the projector. Press the foot release button and lift the front of the projector. This unlocks the foot.
Foot release button
2.Once the image is positioned where you want it, release the button to lock the foot in place.
3.If you need to straighten the image, rotate the round adjustable foot at the back of the projector.
After you select a source, the screen goes dark for a moment before the image appears.
If the image is no longer square after raising it, see page 9.
8 - EPSON PowerLite TW100 Projector | 11/02 |