7 Washer Owner’s Manual
INTRODUCTION
Your new appliance is carefully engineered product. Many times what appears to be a
reason to call service, the problem may require nothing more than a simple adjustment you
can easily make in your own home.
You will be charged for a service call while the appliance is in warranty if the
problem is not caused by defective product workmanship or materials covered
by this warranty.
To avoid a charge for an unnecessary service call, and before calling a serviceman, please
refer to the troubleshooting section for situations that you can remedy. This section is
included on pages 20 of this Owners Manual.
Your Washer is front loading, with an extra large door opening for easier access. It has 10
wash programs
You will obviously want to obtain the best possible wash. By reading and following the
instructions in this booklet you will achieve excellent results.
Please, ensure that the instructions are followed. If you should need any further advice or
assistance, please, contact the dealer where your machine was purchased, or contact
Customer Service at custserv@appliancedesk.com
This appliance is an automatic washer with a capacity of up to:
WASH 14 Lbs
1. The unit must be installed on a strong level floor, and in protected, dry, and well-ventilated
area close to a power and water supply of sufficient capacity, and a sufficient outlet.
2. Installation on Carpet or Wood increases vibrations.
• Carpets - place on light carpet only.
• Wood - brace floor with screws and place additional sheets of plywood before
installation.
3. This unit’s installation and grounding should be done in accordance with local codes by a
qualified installer. “Installation Instructions” are included in this manual for the Installer’s
reference.
4. The unit should be plugged into a properly grounded three (3) prong electrical outlet of
110 V/ 60Hz with minimum 15 amps. It should not be controlled by a wall switch or pull cord
which might be turned off accidentally.