REMOVING THE FOAM DRUM SUPPORT REPLACING THE METAL BOTTOM PAN.
WARNING!!! IN ORDER TO REMOVE THE
FOAM DRUM SUPPORT AND REPLACE THE
METAL BOTTOM PAN, THE BOTTOM OF THE
MACHINE MUST BE ACCESSED. SHIPPING
BOLTS MUST REMAIN IN THE APPLIANCE
WHILE ACCOMPLISHING THIS STEP IN THE
PREPARATION PHASE OF THE INSTALLATION.
Inspecting WHEN TO REMOVE SHIPPING BOLTS!
WARNING!!! TIPPING THE MACHINE TO POSITION IT FOR USE MUST BE DONE WITH THE SHIPPING BOLTS STILL IN THE MACHINE!
TIPPING THE MACHINE WITHOUT SHIPPING BOLTS, CAN CAUSE
THE INNER DRUM TO IMPACT OTHER INTERNAL PARTS, THUS | |
DAMAGING THEM. POSITION THE MACHINE AS CLOSE AS | |
POSSIBLE TO IT’S FINAL POSITION AND THEN REMOVE SHIPPING | |
BOLTS. | √ |
| INSPECT CONTENTS |
[ ] Owners Manual
Brass Pressure Regulators
[ ] (Must be installed on hot and cold water inlet. Failure to do so can damage the internal components and cause water damage for which the installer/owner will be re- sponsible!)
ATTENTION: DO NOT TAKE OUT SHIPPING BOLTS UNTIL MACHINE IS POSITIONED WITHIN A FEW INCHES OF ITS FINAL INSTALL- TION POINT. TIP- PING THE UNIT OR MOVING IT WITHOUT SHIP- PING BOLTS WILL VOID WAR- RANTY.
[] Warranty Registration Card
[] Majestic Literature
[] Hoses have washers in both ends.
Brass Pressure Regulators installed on back of
appliance.
Page 2
