6
ATTACH RAIL TO WALL
Solid Concrete
*Before proceeding with this installation, consult the manufac- turer of your display for recommen- dations on choosing a mounting location that will ensure optimum performance. Location consider- ations might include: mounting height - based on size of display, viewing angle - based on room di- mensions, access to power outlets, cable connections for speakers/ac- cessories, protection from light, heat and vibration, etc.
a Use level and pencil to mark two vertical lines
b Set rail against wall and mark mounting holes along vertical line.
c Hold rail against wall to mark mounting holes. (Note rail orientation - front faces display, back faces wall - illustrated above.)
Verify that the holes are level then drill pilot holes with pilot holes with 3/8” or 10mm Concrete Drill Bit.
WARNING:
Mounting holes must be at least
not solid, reposition mounting holes until both anchors can be fully inserted into solid concrete!
Anchors that are not fully set in solid concrete will not support the applied load resulting in an unstable, unsafe condition which could lead to personal injury and/or property damage. Consult a construction professional if you have any doubt about what this means in regard to your particular situ- ation.
d Insert anchors making sure they are seated completely flush with the concrete surface even if there is a layer of drywall, plaster or other material covering the concrete.
7
Continue to Step 7 on page 16.
6
*
| |
|
|
| |
| |
a |
|
OOOO |
|
| |
b |
|
c | |
|
OO
OO
d
7
6
*
a
PP
PP
b
c
"
PP
PP
d
7