Remote Control Unit
Notes on use
<Point the remote control unit at the main unit’s remote sensor within seven meters (23 feet) of the main unit. There should not be any obstacles between the player and the remote control unit.
<Do not allow direct sun or other light to shine on the remote sensor part of the main unit. This may cause the remote control unit to work incorrectly.
<Note that other units with remote controls may operate incorrectly because of infrared light “overspill” when you operate this remote control unit.
How to insert the batteries
Remove the cover of the remote control unit with a Philips screwdriver. After checking the polarity (+/_) of two AA batteries, insert the batteries, replace the cover and replace the screws.
Battery Replacement
If the distance required between the remote control unit and main unit decreases, the batteries are exhausted. In this case replace the batteries with new ones.
Precautions concerning batteries
<Be sure to insert the batteries with correct positive “+” and negative “_” polarities.
<Use batteries of the same type. Never use different types of batteries together.
<Rechargeable or
<When the remote control unit is not to be used for a long time (more than a month), remove the batteries from the remote control unit to prevent them from leaking.
<If the batteries leak, wipe away the liquid inside the battery compartment and replace the batteries with new ones.
12
Playback (1)
2
1 3 4 5
1Press the POWER button to turn the unit on.
The indicator ring lights in blue.
If the indicator ring is red, press the ON button of the remote control to turn the unit on (page 11).
2Press the OPEN/CLOSE button (L) to open the tray. The tray opens toward to you.
3Insert the disc label side up.
<Make sure the disc is clean, free from scratches and is centered in the tray in order to avoid any malfunction or jamming of the tray or damage to the disc.
4Press the OPEN/CLOSE button (L) again to close the tray.
The tray will close. Be careful not to catch your fingers in the tray.
<The unit then reads the disc (this may take a little time as the mechanism loads and clamps the disc).
5Press the PLAY button (y) to start playback.
During the play mode, the indicator ring of the PLAY button (y) lights in blue.