Troubleshooting Guide
Problem | Possible Cause |
| Remedy |
Failure to | 1. No electrical power to | 1. Check power | |
start or no | unit |
|
|
air delivery | • Fuse blown | • Replace fuse | |
| • Circuit breaker | • Reset breaker | |
| tripped |
|
|
| 2. Belt too loose or tight | 2. | Adjust belt tension |
| 3. Motor overheated | 3. Determine cause of | |
|
|
| overheating |
| • Belt too tight | • Adjust belt tension | |
| • Blower bearings dry | • Grease blower | |
|
|
| bearings |
| 4. Motor locked | 4. | Replace motor |
|
|
| |
Inadequate | 1. Insufficient air exhaust | 1. Open windows or | |
air delivery |
|
| doors to increase air |
with cooler |
|
| flow |
running | 2. Belt too loose | 2. | Adjust belt tension |
|
|
| or replace if needed |
| 3. Pads plugged | 3. | Clean pads |
| 4. Insufficient water | 4. | Clean distribution |
| flow over pads |
| system |
|
|
| |
Motor | 1. Low voltage | 1. Check voltage | |
cycles on | 2. Excessive belt tension | 2. | Adjust belt tension |
and off | 3. Fan shaft tight or | 3. | Grease or replace |
| locked |
| bearings (Disconnect |
|
|
| unit) |
| 4. Bearings dry | 4. Grease bearings | |
| 5. Faulty motor | 5. | Replace motor |
Problem | Possible Cause | Remedy |
Musty or | 1. Stale or stagnate water | 1. Drain pan and clean |
unpleasant | in cooler | pads |
odor | 2. Pads not wetting | 2. Check water |
| properly | distribution system |
| • Dist. tube holes | • Clean |
| clogged |
|
| • Pump not working | • Replace or clean |
| properly | pump (Unplug) |
| • Insufficient water | • Clean water |
| flow over pads | distribution system |
|
|
|
Noisy | 1. Bearings dry | 1. Grease bearings |
| 2. Loose parts | 2. Tighten loose parts |
|
|
|
Inadequate | 1. Inadequate exhaust in | 1. Open windows or |
cooling | building | doors to increase air |
|
| flow |
| 2. Pads not wet | 2. Check water |
|
| distribution system |
| • Pads plugged | • Clean pads |
| • Dist. tube holes | • Clean |
| clogged |
|
| • Pump not working | • Replace or clean |
| properly | pump (Unplug) |
|
|
|
Excessive | 1. Inadequate exhaust | 1. Open doors or |
humidity |
| windows |
in building |
|
|
Limited Warranty
This warranty is extended to the original purchaser of an evaporative cooler installed and used under normal conditions. It does not cover damages incurred through accident, neglect, or abuse by the owner. We do not authorize any person or representative to assume for us any other or different liability in connection with this product.
Terms And Conditions Of Warranty
Lifetime Limited Coverage on water reservoir against any leakage due to defects in material. From date of purchase, if any original component part fails due to defect in material or factory workmanship only, we will provide the replacement part as follows:
One year on the cabinet components.
Two years on the evaporative media.
Exclusions From The Warranty
We are not responsible for any incidental or consequential damage resulting from any malfunction.
We are not responsible for any damage received from the use of water softeners, chemicals, descale material, plastic wrap, or if a motor of a higher horsepower than what is shown on the serial plate is used in the unit.
We are not responsible for the cost of service calls to diagnose cause of trouble, or labor charge to repair and/or replace parts.
How To Obtain Service Under This Warranty
Contact the Dealer where you purchased the evaporative cooler. If for any reason you are not satisfied with the response from the dealer, contact the Customer Service Department: 5800 Murray Street, Little Rock, Arkansas 72209.
This limited warranty applies to original purchaser only
4 | 110497 |