Instructions to Convert Unit to Vertical Duct Configuration
1.Remove the 13 screws holding the Duct in place.
2.Turn the Duct 90 degrees
3.Align the Duct with the 3 holes provided above the blower panel.
4.Insert 3 screws at the top and bottom of the duct.
5.Place the Duct Mount Strip over the side Duct Flange and insert 3 screws into the holes provided.
Proceed with the installation as normal. The side Sealer Channels will go on the same flanges as for a horizontal duct. You may use the Side Sealers provided to close off the window above your cooler’s duct.
LIMITED WARRANTY
This warranty is extended to the original purchaser only. It does not cover damages incurred during shipping or through accident, neglect, or abuse by the owner. Essick Air Products does not authorize any person or representative to as- sume any other or different liability in connection with this cooler.
TERMS AND CONDITIONS OF WARRANTY
The BOTTOM PAN is guaranteed against leakage due to rusting out for Five Years. All other original parts provided by Essick Air Products are warranted against defects in material or factory workmanship for One Year.
EXCLUSIONS FROM THE WARRANTY
Essick Air Products is not responsible for incidental or consequential damage resulting from any malfunction.
Essick Air Products is not responsible for any damage occurring from the use of water softeners, chemicals,
Essick Air Products is not responsible for the cost of service calls to diagnose cause of trouble, or labor charge to repair and/or replace parts.
HOW TO OBTAIN SERVICE UNDER THIS WARRANTY
Contact the Dealer where you purchased the evaporative cooler. sponse from the Dealer, contact the Customer Service Department: Rock, Arkansas 72209.
If for any reason you are not satisfied with the re- Essick Air Products Inc., 5800 Murray Street, Little
6
