Storage Drawer
The storage drawer can be removed. Before removing, make sure drawer is cool and empty.
To Remove:
1.Pull the storage drawer straight back past the drawer stop notch and the end of the side rails.
A B
A. Drawer stop notch
B. End of side rail
2.Lift up the back of the drawer and pull the drawer out.
To Replace:
1.Lift up the back of the drawer and place it inside the range in its fully forward position.
2.Lift up the front of the drawer to a level position.
3.Slowly push the drawer into the range until the drawer side rails engage with the gap in the drawer glides.
A
A. Engage drawer glide.
4.Once the drawer is fully engaged on both sides, slide the drawer back into the closed position.
NOTE: When you are removing and replacing the storage drawer, a slight push may be needed to move the drawer stop notch past the drawer glides.
TROUBLESHOOTING
Try the solutions suggested here first in order to avoid the cost of an unnecessary service call.
Surface burners will not operate
■Is this the first time the surface burners have been used? Turn on any one of the surface burner knobs to release air from the gas lines.
■Is the control knob set correctly? Push in knob before turning to a setting.
■Are the burner ports clogged?
See “Sealed Surface Burners” section.
Surface burner flames are uneven, yellow and/or noisy
■Are the burner ports clogged?
See “Sealed Surface Burners” section.
■On models with caps, are the burner caps positioned properly?
See “Sealed Surface Burners” section.
■Is propane gas being used?
The appliance may have been converted improperly. Contact a service technician or see “Assistance or Service” section.
Surface burner makes popping noises
■Is the burner wet? Let it dry.
Excessive heat around cookware on cooktop
■Is the cookware the proper size?
Use cookware about the same size as the surface cooking area, element or surface burner. Cookware should not extend more than ½" (1.3 cm) outside the cooking area.
Cooktop cooking results not what expected
■Is the proper cookware being used? See “Cookware” section.
■Is the control knob set to the proper heat level? See “Cooktop Controls” section.
■Is the appliance level?
Level the appliance. See the Installation Instructions.
Oven will not operate
■Is this the first time the oven has been used?
Turn on any one of the surface burner knobs to release air from the gas lines.
■Is the electronic oven control set correctly? See “Electronic Oven Control” section.
■On some models, is the Control Lock set? See “Control Lock” section.
Nothing will operate
■Is the power supply cord unplugged? Plug into a grounded 3 prong outlet.
■Household fuse blown or circuit breaker tripped? Replace the fuse or reset the circuit breaker. If the problem continues, call an electrician.
Oven burner flames are yellow or noisy
■Is propane gas being used?
The appliance may have been converted improperly. Contact a service technician or see “Assistance or Service” section.
Cooling fan runs during baking, broiling or cleaning
■It is normal for the fan to automatically run while the oven is in use to cool the electronic control.
14
