Typical flexible connection
1.Use a combination wrench to attach the flexible connector to the adapters. Check that connector is not kinked.
A
| B |
| D |
C |
|
E | F |
| G |
H |
|
A. Pressure regulator | E. Adapter |
connection fitting | F. Use pipe joint compound. |
B. Use pipe joint compound. | G. Manual shutoff valve |
C. Adapter | H. 1⁄2" to 3⁄4" gas pipe |
D. Flexible connector |
|
5.Close the broiler door.
6.Place burners, burner caps and grates on the cooktop.
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death, fire, or electrical shock.
7.Plug into a grounded 3 prong outlet.
Complete Connection
1.Locate gas pressure regulator in the broiler.
A
A. Gas pressure regulator
IMPORTANT: Do not remove the gas pressure regulator.
2.Check that the gas pressure regulator shutoff valve is in the
“ON” position.
Gas Pressure Regulator
Front View | Front | Side View |
| ||
Shutoff valve |
| “ON” Position |
3.Open the manual shutoff valve in the gas supply line. The valve is “open” when the handle is parallel to the gas pipe.
A
B
A. Closed valve
B. Open valve
4.Test all connections by brushing on an approved noncorrosive
Check Operation
Electronic Ignition System
Cooktop and oven burners use electronic igniters in place of standing pilots. When a cooktop control knob is turned to the “LITE” position, the system creates a spark to light the burner. This sparking continues until the control knob is turned to the desired setting.
When the oven control is turned to the desired setting, a hot surface igniter heats to a bright orange and ignites the gas. No sparking occurs. The glow bar remains on while the burner operates.
Check Operation of Cooktop Burners
1.If control panel and knobs were removed earlier, reinstall
knobs. |
| OFF | |
2. Push in and turn each surface |
|
|
|
unit control knob to “LITE” | LITE |
|
|
position. The flame should light |
|
| |
|
|
| |
within 4 seconds. |
|
| LO |
|
|
| |
3. Turn control knob to “HI” | HI |
|
|
|
|
| |
position after burner lights. |
|
|
|
4. Check each cooktop burner for |
|
|
|
proper flame. The small inner |
|
|
|
cone should have a very distinct |
| MED | |
blue flame 1⁄4" (0.64 cm) to 1⁄2" (1.3 cm) |
|
| outer |
long. The outer cone is not as distinct |
| cone | |
|
| ||
as the inner cone. |
|
|
|
5. Turn the control knob quickly to the “LO” |
| inner | |
position after the burner lights. If the |
|
| cone |
|
|
| |
flame goes out, turn the control knob to the “OFF” position.
6.Check each cooktop burner for proper low flame. The low flame should be a minimum, steady blue flame. The flame size should be 1⁄4" to 3⁄8" (0.64 cm to 0.95 cm) high.
10
