HOW TO USE
Power Switch
1.This vacuum has a
2.For bare floor cleaning use suction only (I). For carpet cleaning, use suction and brushroll (II).
The nozzle allows for low profile cleaning. Airflow under the nozzle automatically directs suction to the edges and corners for maximum full width cleaning.
HOW TO MAINTAIN
The instructions in this booklet serve as a guide to routine maintenance. To keep the cleaner operating at top efficiency empty the dust cup and clean the filter after each use. To maximize cleaner efficiency do not allow the dust cup to be filled past the bottom of the filter.
Empty Dust Cup
CAUTION: Turn off the power switch and unplug the electrical cord to service.
On/Off Switch
1
3
2 |
4 |
3.Push dust cup release button.
4.Pull the dust cup away from the main housing.
5.Rotate the dust cup lid counterclockwise to remove. The dust cup filter comes out with the dust cup lid.
6.Empty the dust cup into a waste container. (To clean filter refer to dust cup filter section.)
7.Put the lid back on dust cup. Be sure the gasket on the filter bottom is centered in the inner tube and the lid is aligned correctly on the cup. Rotate the dust cup lid clockwise until it locks.
8.Place the bottom of the dust cup in the main housing. Push the top of the dust cup back into place until it locks.
Remove a Clog in the Base
This model has a
CAUTION: Turn off the power switch and unplug the electrical cord to service.
1.On the bottom of the power nozzle, locate the transparent
2.Remove the port door by squeezing the latch at the back of the nozzle and rotating the port door forward. No tools are needed for this step.
3.Locate and remove clog from the power nozzle. If needed, you may remove the power nozzle from the main body of the cleaner to locate the clog in the neck of the power nozzle.
4.Reattach the
5 | 6 |
7 | 8 |
|
4