Your new vacuum cleaner may be equipped with an optional Cyclonic Bag Saver.
To assemble the cleaner with this option follow these instructions,
otherwise follow the owner’s guide for assembly.
Fig. 1 |
|
|
1 |
|
|
2 | 3 |
|
|
| Fig. 1a |
Fig. 2a | Fig. 2b |
|
| Tab & |
|
| Slot | Handle |
|
| |
Fig. 3 |
|
|
|
| Detail A |
MAX | Nozzle | |
MAX |
| |
| Long Lower Wand | |
| Powercord | |
| Powerhead Unit | |
This accessory reduces the need for frequent bag changes. It does not eliminate the use of a paper bag. To remove the Cyclonic Bag Saver, follow the steps in reverse and reattach the large upper wand.
UNPACKING AND ASSEMBLING
Unpack and check that all the parts are included. The Cyclonic Bag Saver consists of three main parts, see Fig. 1:
1.Cyclonic Housing
2.Cyclone Dust Cup
3.Retaining Clip
Attach retaining clip onto the rear of the cyclonic cup as shown in Fig. 1a.
Attaching the Cyclonic Bag Saver onto the vacuum cleaner
NOTE: If the two long wands have already been assembled to the powerhead, remove the long upper wand to assemble the Cyclonic Bag Saver.
Your vacuum cleaner is equipped with three wands. Locate the short wand.
Fig. 2a Line up the small hole at the top of the short wand with the arrow on the front of the cyclonic housing. Push the short wand into the top of the cyclonic housing until it clicks into place. (You may need to rotate the wand slightly.)
Fig. 2b Attach the cyclonic dust cup onto the cyclonic housing. Place the slot in the cyclonic dust cup over the tab on the cyclonic housing. Then grasp the handle on the cyclonic dust cup, and pivot the cyclonic dust cup up and over the ledge on the cyclonic housing.
Fig. 3 Push the nozzle at the bottom of the cyclone unit into the top of the long lower wand. Adjust the position of the cyclone unit. Push the long lower wand into the powerhead unit. Plug the powercord into the powercord retainer at the top of the cyclonic housing, see Detail A. Attach the powertouch handle following instructions in the owner’s guide.
Important Safety Information
-Do not vacuum surfaces which have been subjected to inflammable solvents.
-Do not pick up any liquid.
-Do not pick up hot ashes which could cause a fire.
Emptying
Empty the dust compartment of the cassette after each use or when the dust cup is filled up to the MAX level, Fig. 3. Detach the dust cup by following the instructions in Fig. 2b in reverse.
Empty the contents into a waste container. To reattach the dust cup again follow the described steps in Fig. 2b.
Maintenance
The Cyclonic Bag Saver can be washed in cold or warm water and a mild detergent. Thoroughly dry the dust compartment with a soft towel before using it again. If the cyclone unit clogs, use the vacuum cleaner to unclog it.
9
