Eureka JO-1800 owner manual Operating instructions Using the inverter

3.led indicators (Red, Yellow and Green lights)

3.1To check the internal battery’s charge status, press the Battery Status But- ton on the front of the Power Pak.

3.2The led lights will indicate the charge level as follows:

a.A red LED indicates a 50% or less charge and you should immediately recharge the Power Pak.

b.A yellow LED indicates a 50 to 75% charge. The Power Pak may be used but should be recharged as soon as possible.

c.A green LED indicates the internal battery is fully charged.

4.charging the internal battery with plug-in wall charger

4.1After removing the Power Pak from the carton, charge it for a minimum of eight hours before using, even if the green charged LED glows.

NOTE: The ON/OFF switch should be in the OFF position to recharge the internal battery.

4.2To charge, plug a wall charger into the socket on the front of the Power

Pak.

4.3Plug the wall charger into 120V electrical wall outlet.

4.4The red CHARGING LED will glow indicating charging.

4.5The green LED will glow when the battery has reached full charge. This could take up to 72 hours due to age and condition of the battery. The charger will automatically drop into a float mode and maintain the battery at full charge without damaging the battery.

4.6Charge the Power Pak as soon as possible after each use.

5.operating instructions

5.1using the inverter

It is important to know the continuous wattage of the device you plan to use with the inverter. The Power Pak must be used with devices drawing 400 watts or less. If the wattage is not marked on the device, an estimate can be made by multiplying the AC input current (Amps) by the AC voltage (120V).

Devices like TVs, fans or electric motors require additional power to start (commonly known as the “starting or peak power”). The Power Pak can supply a momentary surge in wattage; however even devices rated less than the maximum 400 watts can exceed the inverter’s surge capability and cause an automatic overload shutdown.

Make sure the device you are using is compatible with a modified sine wave inverter.

CAUTION: Always run a test to establish whether the inverter will operate

•2 •