Euro-Pro CW230H Technical Specifications, Getting To Know Your Water Filtration Vacuum, Voltage

GETTING TO KNOW YOUR WATER FILTRATION VACUUM

OPERATING INSTRUCTIONS

1.	Water Tank	11.	Manual Suction Control
2.	Power Cord	12.	Flexible Hose Handle
3.	Extension Tube Holder	13.	Flexible Hose
4.	Locking Tab (x2)	14.	Small Squeegee
5.	Carry Handle	15.	Air Driven Turbo Brush
6.	On/Off Power Switch	16.	Convertible Brush
7.	Air Intake Opening	17.	Large Squeegee
8.	Cyclonic Dust Cup	18.	Extension Tubes (x2)
9.	Cyclonic Air Intake	19.	Crevice Tool
10.	Cyclonic Dust Cup Lock	20.	Triangular Water Brush
		21.	Floor Brush

Technical Specifications

Voltage:	120V., 60Hz.
Power:	5 Amps, 600 Watts

Cleaning / Replacing the Pre- Motor Filter

The pre-motor filter is a washable filter but should be replaced every three (3) to six

(6) months depending on usage.

1.Unplug the unit from electrical wall outlet.

2.Lift the locking tabs on either side of the water tank.

3.Remove the cover. The pre-motor filter is located on the underside of the cover. (Fig. 13)

4.Remove the pre-motor filter.

5.Rinse the pre-motor filter in lukewarm water and let the filter air dry completely for 24 hours. Do not use a washing machine to rinse the filter. Do not use a hair dryer to dry it. Air dry only for 24 hours. Never operate the vacuum without the pre-motor filter in place.

6.When the pre-motor filter is completely dry, replace it into the cover of the unit and replace the cover onto the unit.

7.A severely soiled or clogged filter should be thoroughly washed with fresh tepid water. A mild detergent can be used if required.

Cover

Fig. 13

Pre-Motor

Filter

NOTE: DO NOT IMERSE THE ELECTRICAL PART OF THE VACUUM INTO WATER OR ANY OTHER LIQUID.

9.The water tube should also be thoroughly washed. A mild detergent may be used if required.

Cleaning the Flexible Hose

When using the flexible hose for picking up liquids or other soft foods such as baby foods or ketchup, always rinse the flexible hose with warm water after each use before the dirt hardens on the inside of the flexible hose.

1.Empty the water tank of all accumulated water and dirt.

2.Reattach the flexible hose to the canister.

3.In a pail, pour 3 cups of warm water.

4.Turn the unit “On” and insert the flexible hose into the pail to suck up the water. This will rinse out the inside of the flexible hose.

5.Once you have finished, empty the water tank again and store your unit away.

*Illustrations may differ from actual product.

2

7