1.Read all instructions before using your SHARK hand vacuum.
2.Use the system only for its intended use.
3.To protect against a risk of electric shock, do not immerse any part of the system in water or other liquids.
4.Never yank cord to disconnect from outlet; instead, grasp plug and pull to disconnect.
5.Do not allow cord to touch hot surfaces.
6.Do not pull cord around sharp corners or close door on cord.
7.Do not operate the system with a damaged cord or plug, or if the appliance or any other part of the system has been dropped or damaged. To avoid the risk of electric shock, do not disassemble or attempt to repair the SHARK. Return the system to EURO-PRO Operating LLC (see warranty) for examination and repair. Incorrect re- assembly or repair can cause a risk of electrical shock or injury to persons when the SHARK is used.
8.Close supervision is necessary for any appliance being used by or near children. Do not leave the system unattended while connected.
9.Keep hair, loose clothing, fingers and all
parts of body away from opening and moving parts.
10.Do not use to pick up flammable or combustible liquids such as gasoline or use in areas where they may be present.
11.Do not pick up anything that is burning or smoking such as cigarettes, matches or hot ashes.
12.Use extra care when cleaning on stairs.
13.Do not use the hand vacuum without the HEPA dust cup filter in place.
14.This appliance is intended only for household use. Follow all user instructions in this manual.
To reduce the risk of fire, electric shock, or injury:
•Do not leave the SHARK plugged in
when unattended. Unplug the electrical cord when not in use and before servicing.
•Do not allow to be used as a toy. Close attention is necessary when used by or near children, pets or plants.
•Use only as described in this manual. Use only manufacturer’s recommended accessories.
•Do not pull cord, use cord as a handle, close a door on cord, or pull cord around sharp edges or corners. Keep cord away from heated surfaces.
•Use only extension cords UL-rated or cUL at 15 amperes. Extension cords rated for less amperage may overheat. Care should be taken to arrange the cord so that the cord cannot be pulled or tripped over.
•Turn off all controls as applicable before unplugging from electrical outlet.
•Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord.
•Do not handle plug or hand vacuum with wet hands or operate without shoes.
•Do not put any objects into openings. Do not use with any opening blocked. Keep free of dust, lint, hair and anything else that may reduce air flow.
•Store your appliance indoors in a cool, dry area.
•Keep your work area well lit.
•Do not immerse the hand vacuum into water or other liquids.
•Keep end of hose and other openings away from your face and body.
•Use only on dry surfaces.
•Using improper voltage may result in damage to the motor and possible injury to the user. Correct voltage is listed on rating label.
| | 1. | Power cord not firmly plugged | 2. | Check fuse or breaker. |
| | | Replace fuse/reset breaker. |
| HAND VACUUM | | into outlet. | |
| | 3. Call 1-800-798-7398 in the |
| WILL NOT | 2. | No power in wall outlet. |
| | U.S or 1-514-842-8691 in |
| OPERATE | 3. | Needs servicing. | |
| | Canada. |
| | 4. | Thermostat has tripped. | |
| | 4. | Turn the unit off and unplug |
| | | |
| | | | | from outlet. Allow to cool. |
| | | | | |
| | | | 1. | Empty dust cup – |
| | | | 2. | (see page 5). |
| HAND VACUUM | 1. | Dust cup is full. | Turn unit off and unplug |
| | from wall outlet. Remove |
| WILL NOT PICK-UP | 2. | Unit clogged. | | HEPA Dust Cup Filter and |
| OR SUCTION | 3. | HEPA Dust Cup Filter needs | | check for object(s) in air |
| POWER IS WEAK | | cleaning or replacing. | 3. | duct and remove. |
| | | | Clean or replace HEPA |
| | | | | Dust Cup Filter. |
| | | | | (see page 5) |
| | | | | |
| | 1. | Dust cup is full. | 1. | Empty dust cup. |
| | 2. | Review HEPA Dust Cup |
| DUST ESCAPING | 2. | HEPA Dust Cup Filter is not |
| | Filter instructions. |
| FROM HAND | | installed correctly. | |
| | | (see page 5) |
| VACUUM | 3. | There is a puncture/hole in | |
| 3. | Replace HEPA dust cup |
| | | HEPA Dust Cup Filter. |
| | | | filter. (see page 5) |
| | | | |
| | | | | |
| HAND VACUUM | 1. | Hose clogged. | 1. | Remove hose and/or |
| HOSE OR | | bushes. Remove obstruction |
| BRUSHES WILL | 2. | Dust cup is full. | | from hose. |
| NOT PICK-UP | | | 2. Empty and clean dust cup. |
ORDERING REPLACEMENT DUST CUP FILTERS
TO ORDER REPLACEMENT FILTERS
for Models EP035/EP035T2
Call: 1-866-98SHARK (1-866-987-4275)
Monday to Friday 8:30 A.M. - 5:00 P.M. Eastern Standard Time
| FOR TECHNICAL SUPPORT |
| for Models EP035/EP035T2 |
Call: | 1 (800) 798-7398 |
SAVE THESE INSTRUCTIONS
For Household Use Only
WARNING: To reduce the risk of electric shock, this appliance has a polarized plug (one blade is wider than the other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install the proper outlet. Do not modify the plug in any way.
Monday to Friday 8:30 A.M. - 5:00 P.M. Eastern Standard Time or
visit our website: www.sharkvac.com
Please Note: After each Use - Always remove the Filter Debris Screen from the HEPA Dust Cup Filter, then vigorously “TapClean” HEPA Filter until no more dust can be removed. Filter should be rinsed and completely dried at least once a month or when suction appears reduced.
To wash your HEPA Dust Cup Filter, hold filter cartridge by frame flange and rinse under a tap until all observable dirt has been removed. Some discoloration of the HEPA filter material may occur, this is normal and will not affect the filter's performance. When finished, shake off excess water. Do NOT wash in dishwasher.
It is important that when you wash the HEPA dust cup filter, you allow it to dry COMPLETELY before using again. We recommend 24 hours to air dry. DO NOT DRY IN DRYER.
