Fig. A
Wash only once every three (3) months.
Warning: Allow 24 hours for drying before replacing in unit.

OPERATING INSTRUCTIONS cont.

CLEANING & CHANGING THE POST MOTOR FILTER

Cleaning & Changing the HEPA Dust Cup Filter

Warning: Always unplug the unit from electrical outlet before opening the Dust Cup (container).

Important: Do NOT use the HEPA filter cartridge without the debris screen in place.

Warning: After each Use - Always remove the Filter Debris Screen from the HEPA Dust Cup Filter, then vigorously “TapClean” HEPA Filter until no more dust can be removed.

IMPORTANT, Please Note : The “TapClean” HEPA Dust Cup Filter &

Debris

 

Screen

HEPA Filter

 

Fig. 3

 

5. Vigorously “TapClean”

Fig. 4

the HEPA Dust Cup

 

Filter on a hard

 

surface until no more

 

dust is observed

 

falling out from

 

between the pleats of

 

the filter. (fig. 4)

 

1.Disconnect from electrical outlet before cleaning the filter.

2.Filter should be cleaned at least twice a year or when it becomes visible solid.

3.Always operate the cleaner with the filter installed.

4.Do not use a washing machine to rinse the filter.

5.Do not use a hair dryer to dry it.

1.Push the Filter Cover Lock to open the filter cover.

2.Remove the filter from the grill-filter.

3.Rinse filter in lukewarm water and dry the filter completely.

4.Put the filter into the grill-filter.

5.A severely solid or clogged filter should be thoroughly washed with fresh tepid water. A mild detergent can be used if required.

Debris Screen will stop most of the tiniest dust particles and airborne allergens from re-entering the air you breathe. In fact it stops 99.97% of all particles as small as

0.3microns - many times smaller than a human hair!!! Because of this incredible filtration performance, the HEPA Dust Cup Filter will quickly accumulate, inside the white filter folds, many fine dust particles that are difficult to see but which will eventually block or reduce your suction power - if not cleaned properly. This can cause the motor to overheat and the re- settable thermostat to trip. (Should this happen turn off the switch, unplug the unit and allow unit to cool down. Clean the HEPA Filter and Debris Screen as described in this section, then reconnect unit and proceed with vacuuming.)

1.To open the Dust Cup (container), push button and detach the Dust Cup (container ). (Fig. 1)

2.Pull out the HEPA Dust Cup Filter or cloth dust cup filter. (Fig. 2)

Fig. 1

Fig.2

3.Empty the dust from the Dust Cup (container).

4.Separate the debris screen from the HEPA filter cartridge by grasping the debris screen with one hand and the filter frame with the other and pull apart. (fig. 3)

4

6. “TapClean” the Debris

 

Screen or rinse under

 

a faucet until clean.

 

(fig. 5) Remember that

Fig. 5

the Debris Screen

 

must be completely

 

dry before reinstalling

 

in the vacuum.

Debris

 

Screen

7.Replace the Debris Screen on the HEPA Dust Cup Filter and reinstall filter assembly in the vacuum. (not shown)

PLEASE NOTE: The white pleated filter material in the HEPA Dust Cup Filter will discolor over time -This is NORMAL and will NOT affect the performance of the filter. If the HEPA Dust Cup Filter

is properly "TapCleaned” after each use and suction does not return to 100%, then we suggest that the HEPA filter be “TapCleaned” vigorously until no

more dust can be removed, then rinsed under the faucet and allowed to dry for 24 hours before refitting into the vacuum. (Fig. A) This should be done not more frequently than once every 3 months.

CAUTION: The suction hole must be open, free of any obstructions at all times. Otherwise, the motor will overheat and could become damaged.

TROUBLE SHOOTING GUIDE

PROBLEM

 

POSSIBLE REASON

POSSIBLE SOLUTION

 

 

 

 

 

 

1.

Power cord not firmly plugged

1.

Plug unit in firmly.

HAND VACUUM

2.

Check fuse or breaker.

 

into outlet.

 

 

Replace fuse/reset breaker.

WILL NOT

2.

No power in wall outlet.

 

3.

Call 1-800-798-7398.

OPERATE

3.

Needs servicing.

4.

Turn the unit off and unplug

 

4.

Thermostat has tripped.

 

 

from outlet.

 

 

 

 

 

 

 

 

 

 

 

 

1.

Allow unit to cool down,

 

 

 

 

then Restart. Empty dust

 

 

 

2.

cup – (see page 4).

HAND VACUUM

1.

Dust cup s full.

Turn unit off and unplug

 

from wall outlet. Remove

WILL NOT PICK-UP

2.

Unit clogged.

 

 

HEPA Dust Cup Filter and

OR SUCTION

3.

HEPA Dust Cup Filter needs

 

 

check for object(s) in air

POWER IS WEAK

 

cleaning or replacing.

 

 

 

duct and remove.

 

 

 

3.

Clean or replace HEPA

 

 

 

 

Dust Cup Filter.

 

 

 

 

(see page 4)

 

 

 

 

 

 

1.

Dust cup is full.

1.

Empty dust cup.

 

2.

Review HEPA Dust Cup

DUST ESCAPING

2.

HEPA Dust Cup Filter is not

 

Filter instructions.

FROM HAND

 

installed correctly.

 

 

 

(see page 4)

VACUUM

3.

There is a puncture/hole in

 

3.

Replace HEPA dust cup

 

 

HEPA Dust Cup Filter.

 

 

 

filter. (see page 4)

 

 

 

 

 

 

 

 

 

HAND VACUUM

1.

Hose clogged.

1.

Remove hose and/or

HOSE OR

 

bushes. Remove obstruction

BRUSHES WILL

2.

Dust cup is full.

 

from hose.

NOT PICK-UP

 

 

2. Empty and clean dust cup.

5

Page 2 Page 4
Page 3
Image 3
Euro-Pro EP134 Cleaning & Changing the Post Motor Filter, Cleaning & Changing the Hepa Dust Cup Filter
Page 2 Page 4

EP134 specifications

The Euro-Pro EP134 is a versatile and efficient home appliance specifically designed to simplify household cleaning tasks. Renowned for its powerful performance and innovative features, this vacuum cleaner has made its mark among consumers seeking convenience and effectiveness in maintaining their living spaces.

One of the standout features of the Euro-Pro EP134 is its lightweight design. Weighing in at just a few pounds, it allows users to maneuver effortlessly around the home, reaching tight corners and high spaces without straining. The ergonomic handle further enhances the ease of use, enabling long cleaning sessions without discomfort.

The EP134 also boasts strong suction power, drawing in dirt, dust, and debris from various surfaces, including carpets, hardwood floors, and upholstery. Its cyclonic technology ensures that the suction power remains consistent by separating dirt from air, preventing clogs and maintaining performance over time. This feature is particularly beneficial for pet owners, as it effectively captures pet hair and dander.

In addition to strong suction, the Euro-Pro EP134 includes a HEPA filtration system. This advanced filtration captures allergens and fine particles, making it an excellent choice for allergy sufferers. The washable filter is easy to maintain, promoting a clean and healthy indoor environment without the need for frequent replacements.

The vacuum cleaner comes equipped with a variety of attachments that enhance its versatility. The motorized brush roll is ideal for deep cleaning carpets, while the crevice tool allows for precision cleaning in tight spaces. The upholstery nozzle is specifically designed to tackle furniture and drapes, ensuring that every corner of the home can be kept spotless.

Another notable characteristic of the Euro-Pro EP134 is its bagless design. The easy-to-empty dust container minimizes waste and makes emptying a breeze, promoting an eco-friendly approach to cleaning. With a clear viewing window, users can easily see when it is time to empty the container, ensuring uninterrupted cleaning sessions.

In summary, the Euro-Pro EP134 combines powerful suction, advanced filtration technology, and an array of useful attachments housed in a lightweight and ergonomic design. Whether you are looking to maintain a pet-friendly home or just keep your living spaces tidy, the Euro-Pro EP134 is a reliable and efficient cleaning solution that meets the needs of modern households.
Top Page Image Contents