TROUBLESHOOTING GUIDE
PROBLEM |
| POSSIBLE REASON | POSSIBLE SOLUTION | ||
|
|
|
|
| |
| 1. | Power cord not firmly | 1. | Plug unit in firmly. | |
| 2. | Check fuse or breaker. | |||
HAND VACUUM WILL |
| plugged into outlet. | |||
|
| Replace fuse/reset | |||
NOT OPERATE | 2. | No power in wall outlet. |
| ||
| breaker. | ||||
| 3. | Needs servicing. |
| ||
| 3. | Call 1 (800) | |||
|
|
| |||
|
|
|
|
| |
|
|
| 1. | Empty dust cup filter – | |
|
|
|
| (see page 4). | |
HAND VACUUM WILL | 1. | Dust cup filter is full. | 2. | Turn unit off and unplug | |
| from wall outlet. Remove | ||||
NOT | 2. | Unit clogged. |
| ||
| dust cup filter and check | ||||
SUCTION POWER IS | 3. | Dust cup filter needs |
| ||
| for object(s) in air duct | ||||
WEAK |
| cleaning. |
| ||
|
| and remove. | |||
|
|
|
| ||
|
|
| 3. | Clean or replace dust cup | |
|
|
|
| filter. (see page 4). | |
|
|
|
|
| |
DUST ESCAPING | 1. | Dust cup filter is full. | 1. | Empty dust cup filter. | |
2. | Dust cup filter is not | 2. | Review dust cup filter | ||
FROM HAND |
| installed correctly. |
| instructions. (see page 4) | |
VACUUM | 3. | Puncture/hole in dust cup | 3. | Replace dust cup filter. | |
|
| filter. |
| (see page 4) | |
|
|
|
|
| |
HAND VACUUM HOSE |
|
| 1. | Remove hose and/or | |
1. | Hose clogged. |
| bushes. Remove | ||
OR BRUSHES WILL |
| obstruction from hose. | |||
2. | Dust cup filter is full. |
| |||
NOT | 2. | Empty and clean dust cup | |||
|
| ||||
|
|
|
| filter. | |
|
|
|
|
|
ASSEMBLY
Warning: Always unplug from electrical outlet before opening the dust cup (container) (10).
Note: Dust cup filter (8) must be used when operating the hand vacuum.
1.To open the dust cup (container) (10), push button (1) and pull out the dust cup (10). Verify that the dust cup filter (8) is inside, then attach the dust cup (container) (10) to the hand vacuum.
2.To use the Hand Vacuum with the shoulder strap (5), attach it to the unit as shown below.
3.To attach the cleaning brush (6) or crevice brush (7) to the Hand Vacuum, push brush into the suction hole (3), as shown below.
4.To use the flexible hose (11), push the end of the hose into the suction hole (3), then attach the desired brush (6 or 7) to the other end of the flexible hose (11), as shown below.
6 | 3 |