Euro-Pro EP724H owner manual Operating Instructions, Changing & Cleaning the Pre-Motor Filter

PRECAUTIONARY MEASURES

OPERATING INSTRUCTIONS

Important: If the suction opening of the unit, the hose or the chrome telescopic tube are BLOCKED, switch off the vacuum cleaner and remove the blocking substance before you start the unit again.

1. Do not operate the vacuum	4. When pulling out the power plug
cleaner too close to heaters or	from the wall outlet, pull the plug
radiators.	not the power cord.

Changing & Cleaning the

Pre-Motor Filter

The pre-motor filter is located behind the dust cup. See illustration below.

This is a rinseable filter but should be replaced every six (6) months. Never operate the vacuum without ALL the filters in place.

Please Note: The HEPA Dust Cup Filter is washable. It should, however, be replaced every six (6) months to ensure peak performance of your vacuum.

The Post Motor Filter, Pre-Motor Filter and Pre-Filter are washable. They should however be replaced every six

2.Before inserting the power plug into the wall outlet, make sure that your hands are dry.

3.Before you start vacuuming, make sure to remove large or sharp objects that might damage the dust bag.

5.Do not pick up anything that is burning or smoking such as cigarettes, matches or hot ashes.

6.Do not use without all filters in place.

Note: This vacuum cleaner is equipped with a plug and power cord that retract automatically. If the cord or plug get damaged, it must be replaced by a qualified technician.

Warning: Hold the plug when rewinding the cord. Do not allow the cord to whip when rewinding.

•	Push the Power On/Off button to the
	"Off" position and disconnect the
	power cord from the wall outlet.
•	Open the dust cup cover.
•	Remove the pre-motor filter and rinse
	in lukewarm water, let dry completely.
	Do not use a washing machine to
	rinse the filter. Do not use a hair dryer
	to dry it. Air dry only.
• When filter is completely dry, replace
	pre-motor filter back into the unit and
	close the dust cup cover.

Changing & Cleaning the Post Motor Filter

The post motor filter is a washable filter but should be replaced every six (6) months depending on usage. Never operate the vacuum without ALL the filters in place.

•Push the Power On/Off button to the "Off" position and disconnect the power cord from the wall outlet.

•The post motor filter is located on the rear of the vacuum. Remove the filter from the filter grill.

•Rinse in lukewarm water, let dry completely. Do not use a washing machine to rinse the filter. Do not use a hair dryer to dry it. Air dry only.

•When filter is completely dry, replace post motor filter back into the unit and replace the filter cover.

(6)months to ensure peak performance of your vacuum.

Important: Make sure that ALL filters are completely dry before re-installing back in the hand vacuum.

Important: All filters should be checked regularly for signs of damage, preferably after each cleaning task. The filters must be replaced immediately if they become damaged. Always disconnect the vacuum from the electrical outlet when checking the filters.

Cleaning Air Driven Turbo Brush

1.On the base of the turbo brush there is an access door for the turbine. To open for cleaning, push latch toward door and lift door off.

2.Inspect turbine wheel and air passage for debris and/or blockage. Remove debris if present.

3.Inspect the rotating brush for built-up hair or string. If present, remove by carefully cutting with scissors. Avoid damaging or cutting bristles.

4.Once clean, snap the turbine access door back in place. The turbo brush will not function without the access door in place.

3

8