OPERATING INSTRUCTIONS
OPERATING INSTRUCTIONS
4.Place the iron on its heel on a stable, protected surface and allow the iron to heat for approximately two (2) minutes or until the temperature settings on the right side of the LED display panel have stopped flashing.
5.Turn the variable steam control dial to the right to increase the amount of steam. When using extra steam, the iron uses more water and it may be necessary to fill the water tank more often. (Fig. 2)
Fig. 2
Fig. 3
5. Slide the variable steam control up to |
increase the amount of steam. |
(Fig. 3) When using extra steam, the |
iron uses more water and it may be |
necessary to fill the tank more often. |
See page 4 for refilling the iron with |
water. |
6. Steam is produced as soon as the |
iron is held in the horizontal position. |
Steam will stop coming out when the |
iron is put on its heel in a vertical |
position or by setting the variable |
steam control to “0”. |
SELECTING IRON TEMPERATURES
Always read garment labels and follow the manufacturer’s ironing instructions. Refer to the “Ironing Chart” on page 9 for temperature recommendations:
•Use low settings for nylon and other synthetics.
••Use moderate settings for wool, silks, and blends.
•••Use high settings for cottons and linens.
1.Stand the iron upright on its heel.
2.Plug the cord into a polarized, 120V AC electrical outlet.
3.Press the electronic temperature control until you get the desired fabric/temperature setting.
4.The light on the right side of the LED display panel will stop flashing when the desired temperature has been reached. (Fig. 5)
IRONING HINTS
WARNING: To prevent fire, do not leave iron unattended while connected.
•Sort articles to be ironed according to the type of fabric. This will reduce the need to adjust the temperature for different types of garments.
•If you are not sure of the fiber content of a garment, test fabric by ironing a small area such as a seam or inside hem section before ironing a visible area. Start with a low temperature setting and gradually increase to find the best setting.
•When reducing the temperature to iron sensitive fabrics, allow approximately 2 minutes for the iron to cool to the new temperature setting.
•Fabrics such as velour, wool, linen and silk are best ironed with an ironing cloth to prevent shine marks.
BURST OF STEAM BUTTON CAUTION: DO NOT aim iron at face, towards yourself, or anyone else while using or adjusting steam. Burns or serious injury may occur. The burst of steam position is useful when ironing denim, cotton and linens. It provides quick bursts of steam which aid in removing stubborn wrinkles.
The burst of steam feature can be used with Dry or Steam ironing as desired.
1.Make sure the water tank is at least 1/2 filled with water.
2.Select the desired fabric and temperature setting. Place the iron on its heel (on a stable, protected surface) and allow it to heat for approximately 2 minutes.
3.Position variable steam control to the burst of steam position. (Fig. 3)
4.With the iron in a horizontal position, press the steam button several times to prime the pump.
ATOMIZER SPRAY NOZZLE
The atomizer spray nozzle is useful on fabrics with stubborn wrinkles. Press the spray button and a jet of water will spray onto the fabric being ironed. (Fig. 4) The water spray can be used with dry or steam ironing as desired.
Fig. 4
Temp.
Settings
Fig. 5
5
6
