IRONING CHART
NOTE: Always refer to the garment care tag for ironing instructions. Before starting to iron delicate fabrics, it is best to first test the temperature of the iron on a hem or an inside seam.
DIRECTIONS |
|
|
|
|
ON LABEL |
|
|
|
|
| SYNTHETIC |
|
| Please |
| FIBERS, e.g. | SILK | COTTON | |
FABRIC | acrylic, nylon | |||
| polyester |
|
| note |
|
| WOOL | LINEN | |
|
|
|
| |
|
|
|
| that |
LED | MIN |
| MAX |
|
DISPLAY |
|
| ||
• | • • • • • |
| ||
PANEL | onthe | |||
| ||||
|
|
|
| label |
STEAM | 0 | MINIMUM | MAXIMUM | means |
CONTROL | STEAM | STEAM | ||
|
|
|
| ‘THIS |
BURST OF |
|
|
| ARTICLE |
STEAM |
|
|
| |
|
|
| CANNOT | |
|
|
|
| |
|
|
|
| BE |
SPRAY |
|
|
| IRONED!” |
|
|
|
| |
| 9 |
|
|
|
TROUBLESHOOTING
PROBLEM |
| POSSIBLE REASONS & SOLUTIONS |
|
|
|
Iron does not heat | • | Iron should be plugged into a 120V AC electrical |
|
| outlet only. Make sure that the plug is securely in |
|
| the socket. |
| • | Temperature setting too low. Turn to higher |
|
| setting. |
Some odor or small | • | This is normal. |
particles come out of |
| Follow instructions for first use and allow iron to |
steam vents of new |
| steam through |
iron |
| button occasionally to eliminate small white particles. |
|
|
|
Iron does not steam | • | Water tank may be empty or water level is very low. |
|
| Add water. |
| • Make sure that the fabric/temperature setting and | |
|
| the variable steam control are correctly set. For |
|
| maximum steam, (setting ‘Max’ on steam control), |
|
| temperature setting should be set on ‘•••’. |
| • Variable steam control dial is set on “0”. Always allow | |
|
| the iron to reach the selected temperature with the |
|
| variable steam control setting at ‘0’. Make sure the |
|
| temperature setting is set in the correct steam area, |
|
| e.g. ‘•’, and the steam control is not on ‘0’. For more |
|
| steam, turn temperature dial to higher setting, e.g. |
|
| ‘•••’, and the steam control to ‘Max’. |
| • If temperature setting and steam control setting are | |
|
| correct and there is no steam, gently tap the |
|
| soleplate on the ironing board a few times. Move |
|
| the variable steam control from ‘0’ to ‘Max’ a few |
|
| times. |
|
|
|
Water droplets coming | • | Iron may not be hot enough. Set temperature to the |
from steam vents |
| ‘Max’ position. Always allow iron sufficient time to |
|
| heat up before activating the variable steam control. |
| • | Overuse of steam burst. Allow more time between |
|
| each burst. |
| • Iron may have been overfilled. Turn iron off,empty | |
|
| water and follow instructions for filling. |
| • | Steam performance may be low if iron requires |
|
| seasoning. To season, use regular tap water for 1or |
|
| 2 tanks until steam performance improves. |
|
|
|
10
