TROUBLESHOOTING |
ADDITIONAL IMPORTANT SAFEGUARDS
PROBLEM | POSSIBLE REASONS & SOLUTIONS | |
| • Iron should be plugged into a 120V AC electrical | |
Iron does not heat | outlet only. | |
| Make sure that the plug is securely in the socket. | |
| • Temperature setting too low. | |
| Turn to higher setting. | |
| • Iron not properly placed in stand. | |
Thermostat ready light | • This is normal. | |
goes On and Off | The light goes On and Off as the thermostat is | |
| switching the heating element On and Off to | |
| maintain the selected temperature. | |
|
| |
Some odor or small | • This is normal. | |
particles come out of | Follow instructions for first use and allow iron to steam | |
steam vents of new | through | |
iron | occasionally to eliminate small white particles. | |
|
| |
Iron does not steam | • Water tank may be empty or water level is very low. | |
Add water. | ||
| ||
| • Make sure that the temperature control dial is correctly | |
| set. For maximum steam, temperature control dial | |
| should be set on ‘•••’. | |
| • Make sure the temperature control dial is set in | |
| the correct steam area, e.g. ‘•’, for more steam, turn | |
| temperature dial to higher setting, e.g. ‘•••’. | |
| • If temperature setting is correct and there is no steam, | |
| gently tap the soleplate on the ironing board a few | |
| times. | |
Water droplets coming | • Iron may not be hot enough. Set temperature control | |
dial to the ‘Max’ position. Always allow iron sufficient | ||
from steam vents | ||
time to heat up (thermostat light goes off) before | ||
| ||
| pressing the steam button. | |
| • Overuse of steam burst. Allow more time between | |
| each burst. | |
| • Iron may have been overfilled. Turn iron off,empty | |
| water and follow instructions for filling. | |
| • Steam performance may be low if iron requires | |
| seasoning. To season, use regular tap water for 1or 2 | |
| tanks until steam performance improves. | |
|
|
1.Your Steam Station iron is designed to rest only on the iron rest provided with the iron. Do not rest iron on soleplate.
2.Never use or rest iron on an unstable surface.
3.While the iron is hot, never set iron on an unprotected surface - even if it is on its heel rest.
4.WARNING! TO PREVENT ELECTRIC SHOCK OR OTHER INJURY, before filling the iron with water, make sure that the plug is removed from the outlet.
5.CAUTION: Never fill the iron with fabric conditioner, starches or any other solution, as these will damage the steam mechanism. Do not use contaminated water.
6.WARNING! TO AVOID FIRE, never leave iron unattended while it is plugged in.
7.WARNING! TO PREVENT ELECTRIC SHOCK, never immerse the iron in water or other liquid.
8.WARNING! TO PREVENT ELECTRIC SHOCK, never use the iron in a location where it can fall or be pulled into water or any other liquid. If the iron falls into water or any other liquid, unplug it immediately. DO NOT reach into the water or liquid.
9.CAUTION: Never use scouring pads, abrasive or chemical cleaners, or solvents to clean the exterior or soleplate of your iron. Doing so will scratch and/or damage the surface.
10.WARNING! DO NOT aim iron at face, towards yourself, or anyone else while using or adjusting steam. Burns or serious injury may occur.
11.Always store your iron on the iron rest provided with your iron, not on the soleplate. If stored face down, even the smallest amount of moisture will cause the soleplate to corrode and stain.
12.DANGER! Never use the iron if it is damaged or dropped. Using the iron when it is damaged could create the risks of fire, electric shock, injury or death.
Printed in China | 9 |
2
