TROUBLE SHOOTING

PROBLEM

POSSIBLE REASON

POSSIBLE SOLUTION

PRESSURE

 

1. Check plug, socket, fuses,

SAFETY & WARNING INSTRUCTIONS

For safety reasons, it is recommended that you read this manual before attempting to operate this appliance. Failure to follow these instructions can result in personal injury or equipment problems. To help recognize note the following symbols:

WASHER WILL

1. Electrical socket is faulty or

 

breaker.

 

breaker has tripped.

2.

Check that the voltage is

NOT START WHEN

 

2.

Voltage is inadequate.

 

adequate.

THE ON/OFF

 

3.

GFCI has tripped.

3.

Reset/Try another electrical

SWITCH IS IN THE

4. Power cord is not plugged in.

 

outlet.

"ON" POSITION

 

 

 

4.

Plug in power cord.

 

 

 

 

 

 

 

 

 

 

 

1.

Remove and clean water

PUMP DOESN'T

1.

Water intake filter is clogged.

 

intake filter.

2.

Tighten connections/bleed

REACH

2.

Pump is drawing air.

 

system.

ADEQUATE

3.

Diameter of garden hose is

 

3.

Replace with 3/4 inch

PRESSURE OR

 

too small.

 

 

garden hose.

CAVITATES

4.

Water supply is restricted.

 

4.

Check hose for kinks or

 

 

 

 

leaks, open tap fully.

 

 

 

 

 

PRESSURE

 

 

1.

Turn unit and water supply

1.

Excessive air in waterline and

 

off/Bleed system/Hold

WASHER HAS OR

 

trigger down. Allow water to

WILL NOT

2.

pump.

 

flow through the pump for

MAINTAIN

Water supply is restricted.

2.

30 seconds.

PRESSURE

 

 

Check hose for kinks or

 

 

 

 

leaks, open tap fully.

 

 

 

 

 

PRESSURE

1.

Air intake is blocked.

1.

Clean the air intake vents.

WASHER MAKES

2.

Water intake filter is dirty.

2.

Check & clean filter.

EXCESSIVE NOISE

 

 

 

 

 

 

 

 

 

MOTOR DOES

 

 

 

 

NOT RUN

 

 

 

 

CONTINUOUSLY

 

 

 

 

WHEN TRIGGER IS

 

 

 

 

SQUEEZED/

 

 

 

 

MOTOR BUZZES

1.

Net voltage is lower than

1.

Check that the voltage is

WHEN TURNED

 

suggested.

 

adequate.

ON BUT DOES

 

 

NOT

 

 

 

 

START/MOTOR

 

 

 

 

STOPS RUNNING

 

 

 

 

WHILE UNIT IS IN

 

 

 

 

USE

 

 

 

 

8

DANGER

Danger indicates an imminently hazardous situation, which, if not avoided, WILL result in death or serious injury.

WARNING

Warning indicates a potentially hazardous situation, which, if not avoided, COULD result in death or serious injury.

CAUTION

Caution indicates a potentially hazardous situation, which, if not avoided, MAY result in death or serious injury.

NOTE: Information that requires special attention.

Important Safety Instructions SAVE THESE INSTRUCITONS

When using this product, basic precautions should always be followed, including the following:

DANGER

1.Read all instructions before using the product.

2.To reduce the risk of injury, close supervision is necessary when this product is used near children.

3.Always disconnect power (electric units) before disassembling, repairing or changing attachments on the unit.

4.Follow all safety codes as well as the Occupational Safety and Health Act (OSHA).

5.Ensure safety devices are operating properly before each use. DO NOT remove or modify any part of the gun or unit.

6.Know how to stop this unit and relieve pressure quickly. Be thoroughly familiar with the controls.

7.Stay alert - Watch what you are doing.

8.Do not operate this unit when fatigued or under the influence of alcohol or drugs.

Rev. 07/04

1

9.Keep operation area clear of all persons.

10.Do not overreach or stand on unstable support. Keep good footing and balance at all times.

11.Follow maintenance instructions specified in this manual.

12.This product shall be connected to a power supply receptacle protected by a ground fault circuit interrupter (GFCI) (electric power washers only).

13.If product is provided with a GFCI, be sure to inspect the cord and GFCI prior to use. Any repair or replacement of the power cord must be performed by a qualified (licensed or certified) electrical technician.

WARNING

Risk of injection or severe injury. Keep clear of nozzle. Do not discharge streams at persons. This product is to be used only by trained operators. Always remove lance from gun before cleaning debris from tip.

Keep clear of nozzle. NEVER direct high pressure spray at any person, animal or self.

Always wear safety goggles or glasses and protective clothing when operating, performing maintenance or changing accessories.

Never put hands or fingers over the spray tip while operating the unit.

Never try to stop or deflect leaks with any body part.

Always engage the trigger safety latch in the safe position when spraying is stopped even if only for a few minutes.

Always follow detergent manufacturer's label recommendations for proper use of detergents. Always protect eyes, skin and respiratory system from detergent use.

WARNING

SERVICING OF A DOUBLE-INSULATED APPLIANCE.

In a double-insulated product, two systems of insulation are provided instead of grounding. No grounding means are provided for a double-insulated product, nor should grounding means be added to the product. Servicing a double-insulated product requires extreme care and knowledge of the system and should be done only by qualified service personnel. Replacement parts for a double-insulated product must be identical to the

original parts. A double-insulated product is marked with the words

"double Insulation" or "Double Insulated". Product may also be marked with symbol shown.

Page 3
Image 3
Euro-Pro VPW38HB owner manual Safety & Warning Instructions, Trouble Shooting