TROUBLE SHOOTING
SAFETY & WARNING INSTRUCTIONS
continued
PROBLEM |
| POSSIBLE REASON | |
PRESSURE | 1. | Electrical socket is faulty or | |
WASHER WILL | |||
| breaker has tripped. | ||
NOT START WHEN |
| ||
2. | Voltage is inadequate. | ||
THE ON/OFF | |||
3. | GFCI has tripped. | ||
SWITCH IS IN THE | |||
4. | Power cord is not plugged in. | ||
"ON" POSITION | |||
|
|
POSSIBLE SOLUTION
1.Check plug, socket, fuses, breaker.
2.Check that the voltage is adequate.
3.Reset/Try another electrical outlet.
4.Plug in power cord.
WARNING
Do not use pressure that exceeds the operating pressure of any of the parts (hoses, fittings, etc.) in the pressurized system. Ensure that all equipment and accessories are rated to withstand the maximum working pressure of the unit.
• Always hold gun and lance firmly when |
starting and operating the machine. |
• NEVER allow the unit to run with the |
trigger released (OFF) for more than one |
minute. Resulting heat buildup will |
damage pump. |
• NEVER store the pressure washer outdoors |
or where it could freeze. The pump will be |
seriously damaged. |
• Release trigger when changing from high to |
low pressure modes. Failure to do so could |
PUMP DOESN'T | 1. | Water intake filter is clogged. | |
REACH | 2. | Pump is drawing air. | |
ADEQUATE | 3. | Diameter of garden hose is | |
PRESSURE OR | 4. | too small. | |
CAVITATES | Water supply is restricted. | ||
PRESSURE | 1. | Excessive air in waterline and | |
WASHER HAS OR | |||
WILL NOT | 2. | pump. | |
MAINTAIN | Water supply is restricted. | ||
PRESSURE |
|
| |
PRESSURE | 1. | Air intake is blocked. | |
WASHER MAKES | |||
2. | Water intake filter is dirty. | ||
EXCESSIVE NOISE | |||
|
|
1.Remove and clean water intake filter.
2.Tighten connections/bleed system.
3.Replace with 3/4 inch garden hose.
4.Check hose for kinks or leaks, open tap fully.
1.Turn unit and water supply off/Bleed system/Hold trigger down. Allow water to flow through the pump for 30 seconds.
2.Check hose for kinks or leaks, open tap fully.
1.Clean the air intake vents.
2.Check & clean filter.
WARNING
Explosion hazard.
• NEVER spray flammable liquids of use
pressure washer in areas containing combustible dust, liquids or vapors.
• NEVER operate this machine in a closed building or in or near an explosive environment.
WARNING
Do not spray electrical apparatus or wiring.
• NEVER disconnect the high pressure discharge hose from the machine while the system is pressurized. To depressurize the machine, turn the power and water supply off, then press the gun trigger
• NEVER permanently engage the trigger mechanism on the gun.
• NEVER operate the machine without all the components properly connected to
result to damage to the nozzle. |
• This unit must always be used in the |
horizontal position. |
CAUTION
Keep hose away from sharp objects. Bursting hose may cause injury. Examine hoses regularly and replace if damaged. Do not attempt to mend a damaged hose.
EXTENSION CORDS
DANGER
If using an extension cord, use only grounded, three wire extension cords that are in good condition. Use only extension cords that are intended for outdoor use. These extension cords are identified by a marking "Acceptable for use with outdoor appliances; store indoors while not in use." use only extension cords having an electrical rating not less than the product. Do not use damages extension
MOTOR DOES NOT RUN CONTINUOUSLY WHEN TRIGGER IS SQUEEZED/ MOTOR BUZZES WHEN TURNED ON BUT DOES NOT START/MOTOR STOPS RUNNING WHILE UNIT IS IN USE
1.Net voltage is lower than suggested.
1.Check that the voltage is adequate.
the unit (handle, gun/lance assembly, nozzle, etc.).
WARNING
Equipment damage.
• ALWAYS turn water supply "ON" before turning the pressure washer "ON". Running pump dry causes serious damage.
• Do not operate the pressure washer with the inlet water screen removed. Keep screen clear of debris and sediment.
• NEVER operate pressure washer with broken or missing parts. Check equipment regularly and repair or replace worn or damaged parts immediately.
• Use only the nozzle supplied with this machine.
• Never leave the lance unattended while the machine is running.
• Never attempt to alter factory settings. Altering factory settings could damage the unit and will void the warranty.
cords. Examine extension cord before using and replace if damaged. Do not abuse extension cord and do not pull on the cord to disconnect. Keep cord away from heat and sharp edges. Always disconnect from the receptacle before disconnecting the product from the extension cord.
Note: Do not use 16 or 18 AWG extension cords on this product.
DANGER
Failure to follow these instructions can result in serious injury, including death.
WARNING
To reduce the risk of electrocution, keep all connections dry and off the ground. Do not touch the plug with wet hands.
Extension Cord | Allowable Length | ||
|
| ||
25' | 50’ | ||
| |||
|
|
| |
14 AWG | YES | NO | |
|
|
| |
12 AWG | YES | YES | |
|
|
|
9 | 2 |